Instructions for Programming Motorola DTA Remote
Point and Press® (Auto) Programming
1.
Turn on the TV by pressing the
POWER
button on your television.
2.
On your remote, press
OK
and then
MUTE
button together until the LED
illuminates.
3.
Press and hold the
CH UP
button until one
device turns off. While you are pressing
the
CH UP
button, the LED will blink. As
soon as one device turns off, release
the
CH
UP
button.
4.
Press
MUTE
on your remote control:
a.
If the TV turns back on, press
OK
on the
remote to lock in this code. The LED will blink
and go out.
b.
If the TV does not turn back on, press
CH
DOWN
one step at a time until that device turns
back on. Each time you press
CH DOWN,
the
LED will blink. Once you have found a code
that turns the device on/off, press
OK
to lock in
this code. The LED will blink and go out.
Code-Entry (Manual) Programming
1.
Turn on the TV by pressing the
POWER
button on your television set.
2.
On your remote, press
OK
and then
MUTE
button together until the LED illuminates.
3.
Locate the 3-digit code for your brand in the TV Setup Code list and enter it on the keypad of the remote control.
Entry of the correct code will cause your TV to turn off. (If multiple codes are listed for your brand, you may have
to enter several different codes until your TV turns off.)
4.
As soon as you have entered a 3-digit code that turns your TV off, press
MUTE
a.
If the TV turns back on, press
OK
to lock in the code. The LED will blink and go out.
OR
b.
If the TV does not turn back on, enter a different 3-digit set up code until your TV turns back on. Then press
OK
to
lock in the code. The LED will blink and go out.
