6
5
8
1
2
3
7
12
20
18
23
19
16
21
17
22
4
13
14
11
15
9
10
Notifications
Charging\Notification LED:
Data Capture LED:
Slow blinking amber: Battery charging
Solid green: Fully charged
Fast blinking amber: Charging error
Slow blinking red: Charging aged battery
Solid red: Fully charged aged battery
Fast blinking red: Charging error aged battery
Slow blinking blue: Application notification
Green: Good Decode
Data Capture
Charging/Notification
Note:
Remove protective shipping film that covers the touch screen, exit
window and camera window before using.
FEATURES
SIM/SAM CARD INSTALLATION
TC75
QUICK START
GUIDE
1
Scan Button
2
PTT Button (programmable)
3
Back Button
4
Home Button
5
Power Input
6
Search Button
7
Menu Button
8
Touch Screen
9
Light Sensor
10
Proximity Sensor
11
Power Button
12
Receiver
13
Charging/Notification LED
14
Data Capture LED
15
Front-facing Camera
16
Hand Strap Mounting Point
17
Rear-facing Camera
18
Camera Flash
19
Interface Connector
20
Exit Window
21
Volume Button
22
Battery Release Latch
23
Hand Strap
Note 1:
To reset the TC75, press and hold the Power button until the menu
appears and then select
Reset
.
HANDSTRAP AND BATTERY INSTALLATION
Red: Data capture in process
1.
Remove hand strap filler plate.
2
3
4
1.
Lift the access door.
2.
Insert the SIM/SAM card into the card holder. Push the card all the way into the
card holder.
NOTE :
Proper position of the SIM/SAM card — the card connector (i.e., gold contacts)
should be facing down. Nano Slot 1 is default slot for SIM card. Goto
Settings
to
configure the default SIM slot, if enabled by your system administrator.
3.
Replace the access door. Ensure that it
is properly seated.
1.
Lift the access door.
2.
Insert the microSD card into the card holder. Push the card all the way into the
card holder.
NOTE :
Proper position of the microSD card — the card connector (i.e., gold contacts) should
be facing down.
3.
Replace the access door. Ensure that it is
properly seated.
4.
Rotate the battery down into the battery compartment and press the battery
down until it snaps into position.
2.
Insert the hand strap plate into the handstrap slot.
3.
Insert the bottom of the battery into the battery compartment.
5.
Place the hand strap clip into the hand strap attachment slot and pull down to lock into
place.
Blue: Application notification
6.
Lift the hand strap ribbon off the hook material.
7.
Slide the pad and adjust the ribbon for best fit.
8.
Press the ribbon down to secure to hand strap.
SD CARD INSTALLATION
SIM or SAM Card
Nano SIM Card
Nano Slot 1
(default)
Nano Slot 2
