Instructions for the Feeder Activator
THANK YOU for your purchase of the Feeder Activator. Please read this sheet before using the unit.
If you should have any questions about this product or any other Moultrie product, please contact us
using the information on the back of these instructions. Please register your Feeder Activator at
www.moultriefeeders.com/warranty-form to activate your 1-year warranty.
The Feeder Activator allows a feeder motor to be remotely
activated from up to 300 feet away.
The Feeder Activator consists of a Receiver that mounts in your
wildlife feeder and a Handheld Transmitter.
When the button is pressed on the Transmitter, a signal is sent
to the Receiver which activates the Feeder motor for a period
of five seconds.
The transmitter is powered from an onboard battery, and the
Receiver is powered from your feeder battery.
The Feeder Activator works with most wildlife feeders that
meet the following requirements:
a) When the battery is installed in the feeder, the positive
and negative contacts are exposed and accessible -
enabling the connection of the Feeder Activator
power wires (with alligator clips).
b) The two wires that run between the feeder circuit board
and the motor are accessible - enabling the connection
of the Feeder Activator motor wires.
NOTE: On Moultrie feeder kits, there are two separate
wires labeled “Feeder Activator Connection” that should
be used for connection.
The Feeder Activator may be used in a metal Feeder enclosure
if the Antenna Wire can be routed outside the box.
Disconnect the battery from the Feeder. Holding one of the
provided Connectors in the orientation shown, push the
Receiver’s Red Motor Wire into the rear hole until it reaches
the internal stop.
Slide the positive wire that runs between the Feeder’s circuit
board and the motor into the side of the Connector as shown.
The positive wire may be red in color, marked “positive”, or not
identified. If it is not identified, select either wire.
ABOUT THE FEEDER ACTIVATOR
A
WIRING THE RECEIVER – NON-MOULTRIE KIT
B1
With pliers, squeeze the metal contact tab down until it is
even with the surface of the plastic. Close the Plastic Cover
until it snaps into place.
Repeat steps 1 through 3 for the Black Negative Wire.
Transmitter
Antenna
Activation
Button
Handheld
Transmitter
Status
Light
Receiver
Mounts
Inside
Feeder
Antenna
Wire
Battery
contacts
must be
accessible
NOTE: If installating on a Moultrie feeder kit,
you can proceed to Section B2
Receiver’s
Motor Wire
Connector
Metal Contact Tab
Motor Wire from
Feeder Circuit Board to Motor
Plastic
Cover
MFHP53863_Feeder Activator_MANUAL_ENGLISH_8-27-21.indd 1
MFHP53863_Feeder Activator_MANUAL_ENGLISH_8-27-21.indd 1
8/26/21 2:39 PM
8/26/21 2:39 PM
