– 1 –
– 2 –
– 3 –
*1802021900011*
P/N: 1802021900011
MPC-2190 Series
Quick Installation Guide
Second Edition, March 2015
1.
Overview
MPC-2190 panel computers feature advanced Intel
processors—3rd generation Ivy Bridge Core or Celeron—matched
to 4 GB of system memory, delivering a reliable, high-performance
platform of wide versatility for use in industrial marine
environments. With its RS-232/422/485, NMEA 0183, and Gigabit
Ethernet LAN ports, the MPC- 2190 panel computer supports a
wide variety of serial- and marine-specific interfaces alongside
high speed IT communications and native Ethernet redundancy.
The MPC-2190 series comes with a range of standard display
enhancements useful in industrial environments (including 0 to
100% full range dimming, 178°/178° wide viewing angles,
optional optical bonding, and/or a multi-touch screen), as well as
Moxa’s SavvyTouch display controls.
2.
Package Checklist
Before installing the MPC-2190, verify that the package contains
the following items:
•
MPC-2190 panel computer
•
2 keys for the removable storage trays
•
1 2-pin terminal block for DC power input
•
2 5-pin terminal blocks for NMEA 0183 v2 interfaces
•
Hard disk drive installation kit
•
Documentation and driver DVD
•
Quick installation guide (printed)
•
Warranty card
NOTE: Please notify your sales representative if any of the
above items are missing or damaged.
3.
Hardware Installation
Bottom View
Front View
SavvyTouch Display Control Buttons
The following table describes the SavvyTouch display controls on
the front surface of the MPC-2190. These intelligent controls will
light up with a simple hand-wave above the area of the screen
where they are located.
Name
Displayed
Color
Control Function / Color
Legend
Power
Green
Power is on and functioning
normally
Red
Power standby and system shut
down
Off
Power is off.
Brightness
White
+: To increase brightness of panel
-: To decrease brightness of panel
Info
Off
System functioning normally
Red
System hardware error
Storage
Red (on) Storage drive is functioning
properly
Red
(blinking)
Drive is accessing or writing data
Off
Drive is offline.
Display
mode
(ECDIS
models
only)
White
Displays the brightness mode
Off
Panel brightness out of ECDIS
standard range
Installing the MPC-2190 Series
Desktop
The MPC-2190 comes with optional brackets that allow you to
install the panel computer on a horizontal surface, such as a
desktop. Three round screws are required for each bracket. Place
the panel computer panel-side down on a clean, flat,
non-scratch-surface. See the figure below for details about screw
specifications, locations, and their torque value.
To protect the computer from overheating, leave some ventilation
space between the MPC-2190 and other equipment. Do not leave
the panel lying on its back equipment, nor put objects on the
computer, as this might damage internal components.
Wall Mounting
The MPC-2190 Series comes with 14 optional clamp mounts that
allow for installation onto a wall (where space has been cut out to
accommodate the rest of the hardware) or into computing stations
where a flush mount is desired.
The maximum thickness of a
surface to which the computer may be clamped is 11 mm.
For a secure mounting, all 14 clamps must be used. The clamp
arms are fastened into slots on all four sides of the MPC-2190. Use
the short M4 SUS screws to fasten the clamp arms to the
MPC-2190 mounting slots, as shown in the magnified inset in the
diagram just below. Next, use the clamps to fasten the computer
to its mounting point; please note the torque value that is shown in
the figure inset, at the top of the next page.
