MREL DATATRAP II, Quick Start Manual

QUICK START GUIDE

1 

2

3

4

A:

UNLOCK THE LATCHES.

B: 

OPEN THE DATATRAP II™.  

INSTALL THE DATATRAP II™ SOFTWARE

ON THE COMPUTER.

A

A

B

TURN ON THE DATATRAP II™ BY

PRESSING THE POWER BUTTON

FOR 2 SECONDS. THE LED 

SCREEN WILL TURN ON AND THE

STATUS LIGHT WILL FLASH.

PRESS THE INFO BUTTON AND THE DISPLAY WILL

SHOW THE BATTERY LEVEL REMAINING AS SHOWN

ABOVE. IF THE BATTERY NEEDS CHARGING, PLEASE 

SEE STEP 5, ELSE GO TO STEP 6.

PROGRAM THE DATATRAP II™ BY

SELECTING CHANGE SETTINGS AND

NUMBER OF TESTS OPTION AND

CLICKING NEXT.

TURN OFF THE DATATRAP II™ BY PRESSING

THE POWER BUTTON AND THEN CONNECT

THE BATTERY CHARGER TO THE DC IN PORT.

THE DISPLAY ON THE DATATRAP II™ WILL 

DISPLAY CHARGING.

WITH THE DATATRAP II™ POWERED ON,

CONNECT THE USB COMMUNICATIONS CABLE

TO THE DATATRAP II™. THEN CONNECT THE

OTHER END OF THE USB COMMUNICATIONS

CABLE TO THE PC WHERE THE SOFTWARE WAS

INSTALLED. 

START THE SOFTWARE FROM

START / PROGRAMS / MREL / DATATRAPII

AND CLICK ON 

PROGRAM DATATRAPII

INSTALL USB DRIVERS FOR THE

DATATRAP II™ FROM

MyDocuments/MREL/DataTrapII/driver

FOR MORE HELP, GO TO

www.mrel.ca/usb/dt2

5

6

7

8

9

CHOOSE THE TOTAL NUMBER OF TESTS

MORE TESTS = LESS TIME PER TEST

CHOOSE THE NUMBER OF CHANNELS YOU 

REQUIRE BY TURNING THEM OFF OR ON.

10

11

SET THE

RECORDING RATE 

FOR EACH CHANNEL.

SET THE TRIGGER TYPE FOR EACH CHANNEL.

WHEN ALL CHANNELS ARE SET, PRESS NEXT.

12

13