Enclosure Volume: .9 Cubic Foot, Sealed
READ ALL DIRECTIONS CAREFULLY BEFORE BEGINNING
MOUNTING LOCATION:
The enclosure mounts in trunk of two or four door Accord on driver’s side.
TOOLS FOR INSTALLATION:
Powered Screwdriver
INSTALLATION:
Follow the steps below
1
. Place gasket provided around woofer hole cutout. Connect black wire to the negative side of woofer and red to the posi-
tive side. Using screws provided install woofer into enclosure, making sure not to overtighten screws to avoid stripping.
2.
Place enclosure in trunk of vehicle, with woofer firing towards the rear of the vehicle on drivers side.
3.
Make speaker connections to the enclosure from the amplifier, loosen terminals knobs (a 13-mm nut driver can be used.)
Connect speaker wires from amplifier to enclosure, positive to red terminal knob and negative to black terminal knob.
4.
Using screws provided, install the enclosure into vehicle as shown below.
FACTORY SPEAKER WIRE COLORS
Wire colors for the rear speakers are left side, blue/yellow (positive), gray/white (negative). Right side, red/yellow (positive),
brown/white (negative).
Although every effort has been made to assure proper wiring color, Mitek is not responsible for any changes made by the
vehicle manufacturer which sometime occur. If wiring colors do not match then physical verification is required. These in-
structions are guidelines only and in no way are intended to replace a professional installation. As always before screwing
and drilling check to make sure you will not damage wires, hoses or cause damage to the vehicle.
HA10
See back for Maximum Enclosure Mounting Specs
