background image

Instruction Sheet

Subject: Installations Instructions

Air Compressor Kits

 

1 of 9

 

Part Number 020006402  12/2014

MULTIPLEX 

2100 FUTURE, SELLERSBURG, IN 47172

800-367-4233 

WWW.MANITOWOCBEVERAGE.COM/US

Importar

Read the following warnings before beginning an 

installation. Failure to do so may result in possible death 

or serious injury.

n

Wtoaiag

Tp Avpid Seoipus ajuoy

DO

 Adhere to all National and Local Plumbing and 

Electrical Safety Codes.

DO

 Turn “off” incoming electrical service switches when 

servicing, installing, or repairing equipment.

DO

 Check that all flare fittings on the carbonation 

tank(s) are tight. This check should be performed with a 

wrench to ensure a quality seal.

DO

 Inspect pressure on regulators before starting up 

equipment.

DO

 Protect eyes when working around refrigerants.

DO

 Use caution when handling metal surface edges of 

all equipment.

DO

 Handle CO

2

 cylinders and gauges with care. Secure 

cylinders properly against abrasion.

DO

 Store CO

2

 cylinder(s) in well ventilated areas.

DO NOT

 Throw or drop a CO

2

 cylinder. Secure the 

cylinder(s) in an upright position with a chain.

DO NOT

 Connect the CO

2

 cylinder(s) directly to the 

product container. Doing so will result in an explosion 

causing possible death or injury. It is best to connect the 

CO

2

 cylinder(s) to a regulator(s).

DO NOT

 Store CO

2

 cylinders in temperature above 125°F 

(51.7°C) near furnaces, radiator or sources of heat.

DO NOT

 Release CO

2

 gas from old cylinder.

DO NOT

 Touch refrigeration lines inside units. Some 

may exceed temperatures of 200°F (93.3°C).

Importar

Water pipe connections and fixtures directly connected 

to a potable water supply shall be sized, installed and 

maintained in accordance with Federal, State, and Local 

codes.

n

Wtoaiag

Dtageo pf Elecroic Shpck

Disconnect and lock out all electrical power sources 

before performing service or maintenance on this 

machine — except when electrical tests are being 

performed by qualified service personnel.

Summary of Contents for 00212053










Reviews: