background image

SAVE THESE INSTRUCTIONS

LVM-125/25

0

(LVS Catalog #: CEPS-125/250)

INSTRUCTION MANUAL

EMERGENCY POWER EQUIPMENT

UNIVERSAL MICRO INVERTER

PURE SINUSOIDAL AC OUTPUT

OUTPUT VOLTAGE AUTO SETTING EQUAL TO INPUT VOLTAGE

AUTO DIMMING (0-10V) OF CONNECTED LOAD 

IMPORTANT SAFEGUARDS

WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, 

INCLUDING THE FOLLOWING

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. To prevent electric shock, switch off the mains power until installation is complete and

AC input power is supplied to this product.

2. This product requires an unswitched AC power supply of 120-277V, 50/60Hz.

3. Ensure all connections are in accordance with National Electrical Code or Canadian

Electrical Code and all local regulations.

4. To reduce the risk of electrical shock, disconnect both normal power, emergency power

supplies and unit connector of this product before servicing.

5. For emergency operation of LED, incandescent, fluorescent fixtures and screw-base

lamps.

6. The product has a metallic housing and is suitable for installation in air handling/plenum

spaces in accordance with the National Electric Code.

7. Use this product in 0°C minimum, 50°C maximum ambient temperatures (Ta). To ensure

the emergency operating time over 90 minutes, the output emergency power of LVM-125

/250 should be maximum of 125W for the LVM-125 and 250W for the LVM-250.

8. Use with grounded, Listed, dry or damp location rated fixtures and the case should be

grounded.

9. Do not use outdoors. Do not mount near gas or electric heaters.

10. The use of accessory equipment not recommended by the manufacturer may cause an

unsafe condition and void warranty.

11. Do not use this product for other than intended use.

12. Installation and service should be performed by qualified service personnel.

13. This product should be mounted in locations and at heights where it will not readily be

subjected to tampering by unauthorized personnel.

10E22

44 South Commerce Way, Bethlehem, PA 18017

Technical Support: 610-868-5400

THIS PRODUCT CONTAINS A RECHARGEABLE LITHIUM IRON PHOSPHATE BATTERY.

THE BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.

WWW.MYERSEPS.COM

WWW.LVSCONTROLS.COM

E95719

3KLH

INSTALLATION MANUAL

LFP

Summary of Contents for LVM-125






Reviews: