INSTALLATION INSTRUCTIONS
NI SCXI -1378
Terminal Block for the NI SCXI-1130
This guide describes how to install and connect signals to the
National Instruments SCXI-1378 terminal block to configure
the SCXI-1130 as a:
•
4x64, 1-wire matrix
•
4x32, 2-wire matrix
The SCXI-1378 terminal block installs in front of the SCXI-1130 switch
module. The SCXI-1378 has screw terminals available to connect signals
and trigger input and trigger output signals to the terminal block.
Refer to the
NI Switches Getting Started Guide
to determine when to install
the terminal block.
Conventions
The following conventions are used in this guide:
»
The
»
symbol leads you through nested menu items and dialog box options
to a final action. The sequence
File»Page Setup»Options
directs you to
pull down the
File
menu, select the
Page Setup
item, and select
Options
from the last dialog box.
This icon denotes a tip, which alerts you to advisory information.
This icon denotes a note, which alerts you to important information.
This icon denotes a caution, which advises you of precautions to take to
avoid injury, data loss, or a system crash.
™
̭͈Ρ΅νιϋΠ͉ͅȂུࢊβȜΐ͜܄̞̳ͦ̀͘͘ȃ