background image

BHM 

01/14/16 

NTV-DOC034 

rB2 

 

1 | 

P a g e

 

Agreement

End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for 

misuse of its product.  If you do not agree, please discontinue use immediately and return product to place of purchase. This product is 

intended for off-road use and passenger entertainment only.

 

 

3950 NW 120

th

 Ave, Coral Springs, FL 33065 TEL 561-955-9770 FAX 561-955-9760 

www.nav-tv.com

         

info@nav-tv.com 

RGB-LEX+ 

NTV-KIT062 

 

 

 
 
 
 
 
 
 
 
 

 

Overview 

 
The RGB-LEX+ allows the user to add an aftermarket backup camera to the factory navigation 
screen in select Toyota/Lexus vehicles equipped with navigation 

only

. A secondary video input 

is included on the RGB module and can be viewed at any time via the provided toggle switch 
(optional). 

NOTE: the factory media system must be in navigation mode for any camera 

image/video to display. 

 

Kit Contents 

 

 

 

 

 

 

 

 
 
 

RGB Video Harness 

NTV-HAR209 

RGB Power Harness 

NTV-CAB034 

RGB-LEX+ Converter 

NTV-INT005 

Summary of Contents for RGB-LEX+ NTV-KIT062

Page 1: ... Springs FL 33065 TEL 561 955 9770 FAX 561 955 9760 www nav tv com info nav tv com RGB LEX NTV KIT062 Overview The RGB LEX allows the user to add an aftermarket backup camera to the factory navigation screen in select Toyota Lexus vehicles equipped with navigation only A secondary video input is included on the RGB module and can be viewed at any time via the provided toggle switch optional NOTE t...

Page 2: ...RGB pin outs If your vehicle is not listed contact NAV TV tech support at 561 955 9770 for vehicle specific diagrams 3 Cut the Red Green Blue and Sync wires in half one at a time Refer to the diagram on page 3 and make connections Note RGB Ground should not be cut Splice the ground leads to the RGB ground or other ground Note 2 While these pin locations should be accurate we recommend testing each...

Page 3: ...se discontinue use immediately and return product to place of purchase This product is intended for off road use and passenger entertainment only 4 From the provided RGB Power Harness connect the following a the black wire to ground b the red wire to an 12v accessory source may be found on another plug on NAV unit c the blue wire to a Reverse lamp 12v from module runs with the toggle switch Basic ...

Page 4: ...re on the interface see s 12v the navigation screen will switch to Video 2 source This wire should be connected to a reverse lamp 12v Toggling the provided switch will switch the factory navigation screen to Video 1 source Note if not adding a second video source leave the switch in whichever position where the factory NAV displays properly on the media screen Back up camera image or any other ima...

Reviews: