Quick
Start
Guide
1
Gather the tools and materials
for the installation
Caution:
Observe all safety precautions
when you are operating electrical tools
or hand tools.
The following installation instruc-
tions are recommendations for
typical installations. Please refer
to project plans and specs for any
deviation to these instructions.
2
Excavate a trench for the
channels
Excavate a trench with a minimum concrete-
surround, by load class:
n
Class A: each side 4", depth below 4"
n
Class B: each side 4", depth below 4"
n
Class C: each side 6", depth below 6"
n
Class D: each side 8", depth below 8"
Note:
The channel must be recessed 1/8” for
pedestrian traffic and 1/4” for vehicular traffic.
Note:
The channel must be surrounded on all
sides by a minimum of 4" of concrete for a Class
A installation. For a complete description of
installation types, see
Load Class Installation
on
page 4
.
n
Shovel
n
Hammer
n
Butyl caulk or adhesive silicone sealant
n
Caulking gun
n
Stringline
n
Level or laser line
n
Phillips screwdriver
n
Concrete vibrator
n
#4 rebar (
1/2
")
n
Tie wire and self-tapping screws
n
Pliers and cordless screwdriver
