background image

ISSUED: 11-16-05  SHEET #: 055-9447-2

Visit the Peerless Web Site at www.peerlessmounts.com

1 of 8

For customer care call 1-800-729-0307 or 708-865-8870.

Read instruction sheet before you start installation and assembly.

Maximum Load Capacity: 25 lb (11 kg)

Installation and Assembly - All-in-One Projector Mount

for NEC

 Projectors

Model:
VL80CM

Installations:

To Wood Joist Finished Ceilings,
Exposed Wood Joists, or Wood Beam Ceilings ............................................................................ step 2, page 3

To Concrete Ceilings ........................................................................................................................ step 3, page 4

Applications:

Threaded Rod .................................................................................................................................. step 4, page 5

Extension Column ............................................................................................................................ step 5, page 5

Projector Alignment:

Adjusting Roll, Pitch, and Yaw ...................................................................................................... step 12, page 8

Turn to the appropriate page for your ceiling installation.

R

This product is intended for use with UL
Listed products and must be installed by a
qualified professional installer.

NOTE: Accessories listed in the included sheet, as well as other parts, can be ordered
through Peerless by calling 1-800-729-0307 or visiting www.peerlessindustries.com.

• Installer must verify that the ceiling will safely support four times the combined weight of all attached equipment and

hardware.

WARNING

Summary of Contents for VL80CM









Reviews: