Quick Install Guide
Phantom HD
Unpacking and Inspection
Carefully unpack the Phantom HD chassis, power cords,
mounting rails, and cables. The Phantom HD chassis is
delivered with the following components:
• 1––Phantom HD chassis
• 2––Power cords
• 1––Rack mounting rails (left and right rail sets)
• 1––Package containing rack mounting fasteners
• 1––Rack handle accessory kit
• 1––AC power cord bracket
• 1––Power cord cable clamp
Check the packing slip against parts received. If any
component is missing or damaged, contact Net Optics
Customer Service immediately at (408) 737-7777 or at
support@netoptics.com
.
Rack Mounting the Phantom HD Chassis
© 2013 by Net Optics, Inc. Net Optics® is a registered trademark of Net Optics, Inc. Phantom HD
TM
is a trademark of Net Optics, Inc.
800-0231-001 04/13
The Phantom HD chassis is designed for rack mounting in
a 19-inch equipment rack and occupies one rack unit. Each
mounting slide has two components that comprise the
slide: an outer member and an inner member.
To rack mount the Phantom HD chassis:
1. Align and fasten the inner rail extensions to both sides
of the Phantom HD chassis using two screws on each
side.
2. Attach the outer rails to the outside of the front outer
rails, aligning the pins with the slides.
Both rail ends must face in the same direction.
3. Adjust the outer rails to the proper distance so that the
rails fit together snugly in the rack.
4. Secure the front outer rails to the front rack posts using
two screws and washers on each side of the equipment
rack.
5. Secure the rear outer rails to the rear back posts using
two screws and washers on each side of the equipment
rack.
6. Slide the Phantom HD chassis into the rack by aligning
the inner rails with the outer rails and pushing the
chassis in until you hear the locking tabs click into
position.
Inner Rails
(pre-installed on chassis)
Inner Rail
Extensions
Secure to the
Front of the Rack
Secure to the
Rear of the Rack
Attach Outer Racks
together
Phantom HD
