New Holland
Forage Blower Specifications
F62B
Page 1 of 1
MODEL
F62B
LENGTH
108 in. (2,743 mm)
WIDTH
100 in. (2,540 mm)
WEIGHT
1,605 lbs. (729 kg)
BLOWER
Blowing height*
Over 100 ft. (Over 30 m)
Blower housing
60 in. dia. (1,524 mm)
Paddles (adjustable)
8
Paddle tip speed
8,460 ft./min. (2,579 m/min.)
Drive
Direct PTO
HOPPER
Diameter
Auger–12 in. (305 mm)
Length
Auger–50 in. (1,270 mm)
Width
37 in. (940 mm)
Height from ground
Adjustable–20
1
⁄
2
in. (520 mm)
to 27
1
⁄
8
in. (699 mm)
Feeder type
Auger
DRIVELINE PROTECTION
Shearbolt
PTO
540 rpm
TIRES
4.80–8 “C” load range
CAPACITY
(with adequate power)
Corn silage*
Up to 180 tons/hr. (163 mt/hr.)
Haylage*
Up to 110 tons/hr. (100 mt/hr.)
OPTIONAL EQUIPMENT
Pipe Clamp
Kwik Pipe Bundle
Telescoping Pipe Section
Hinged Deflector
Safety Tow Chain+
* Capacity and height will depend upon tractor horsepower, type of crop, moisture content, length of cut, as well as general maintenance of pipes and spout.
+ Available from New Holland Service Parts.
Safety begins with a thorough understanding of
the equipment.
Always make sure you and
your operators read the Operator’s Manual
before using the equipment. Pay close
attention
to
all
safety
and
operating
decals and never operate machiner y
without all shields, protective devices
and structures in place.
Design,
materials
and/or
specifications are
subject to
change
without
notice
and
without
liability
therefor.
Specifications are applicable to units sold in Canada, the
United States, its territories and possessions, and may
var y outside these areas.
© 2008 CNH America LLC
New Holland is a registered trademark of CNH America LLC.
Visit our Web site at
www.newholland.com/na
. Or, call toll-free
866-NEW-HLND (866-639-4563).
