background image

Model  FRS2020 

19” Rack Mount Chassis 

with Dual Power Supply System 

Installation and 

Operation Manual 

NITEK

 

®

 

De Schans 19-21 2a 
8231 KA Lelystad 
Tel: +31(0)320-230005  
E-mail: info@nitek.nl 
WWW.NITEK.NL 

USA

 

5410 Newport Drive, # 24 
Rolling Meadows, IL  60008 
Phone: (847) 259-8900  
Fax: (847) 259-1300   
E-mail: info@nitek.net  
WWW.NITEK.NET 

EUROPE

 

09172013 

680160112 

Reduce risk of fire or electrical shock. Do not 
expose this product to rain or moisture. 

Note: This installation should be made by a qualified 
service person and conform with local codes. 

Safety 

 

The FSS20111S uses a Class 1 laser system in accordance with IEC 60825-1. 
It is always advisable to follow good practice when working with optical fiber systems. This includes: 
•  Do not stare with unprotected eyes at fiber ends or connector faces. 
•  Use only approved filtered or attenuating viewing devices. 
•  For other safety issues and advice on good practices associated with optical fiber systems see IEC 60825-1 or your 

local safety officer

.

 

Front View 

The FRS2020 can be either rack mounted, or resting on a desktop. 

 
NOTES: 
1.  Use all four mounting screws to properly secure the unit to the rack. 
2. 

Mechanical loading  -  The mounting ears were designed for two ears to support one unit.

 

3.  Air-Flow  -  Leave space on the rear of the unit for airflow into cooling fans on back of the unit.  

Adequate air flow 

is required for safe operation.

 

4. 

Cable space  -  Allow for proper bend radius of the fiber cables exiting the front of the unit.  Do not exceed the 
recommended minimum bend radius of the fiber cable.

 

Device Mounting Options 

Introduction 

 
The Nitek FRS2020 unit provides a means of centralizing individual video data modules, from the FSS20111S system, 
together in a single chassis.  The FRS2020 uses the standardized dimensions for a 19 inch 2-Unit rack mounted 
chassis.  The chassis can accommodate, in any combination, of up to 16 video card modules from the FSS20111S 
system.  The chassis design supports ‘hot swapping’ of the FSS20111S ‘plug and play’ video cards, allowing the system 
to be powered up while cards are removed and installed.  The FRS2020 is configured as a dual power supply, both 
power supplies work independently from each other.  In the case of a major failure by one of the power supplies the 
other supply will continue to provide the proper power to all of the video cards.   

Reviews: