1
Nordson Corporation
OPERATOR CARD
P/N 187695-03
Manual Iso-Flo
r
HD and VC Voltage Block Systems
Safety
WARNING:
Operating the system with more
than one spray device connected to it may be
unsafe and in violation of National Fire
Prevention Association (NFPA) regulations.
It also voids the warranty. If this occurs,
Nordson Corporation will not be responsible
for the performance or life of the system.
WARNING:
Allow only qualified personnel to
perform the following tasks. Follow the
safety instructions in this document and all
other related documentation.
WARNING:
Risk of electrical shock. Shut off
the electrostatic voltage before opening the
cabinet door. Failure to observe this warning
could result in personal injury, death, or
equipment damage.
WARNING:
Make sure the room where you
are working is sufficiently ventilated during
the flushing procedure. Avoid breathing
vapors over prolonged periods of time.
WARNING:
Ground all electrically
conductive equipment in the spray area.
Check the Iso-Flo cabinet ground. Make
sure all internal and external connections are
clean and secure. Ungrounded conductive
equipment can store a static charge which
could ignite a fire or cause an explosion if a
hot spark is discharged.
CAUTION:
Failure to use a compatible
cleaning solution could cause equipment
damage or fluid contamination.
To use this equipment safely,
S
follow the instructions in this operator’s card and
the referenced manuals.
S
obtain and read the Material Safety Data Sheets
for all materials used.
Introduction
This operator’s card contains basic information
necessary for daily operations. For other information,
refer to the product manual.
The procedures and figures in this document can
vary depending on your system setup, safety
regulations, and system requirements.
