1
USER INSTRUCTIONS
ADJUSTABLE BATH-STEP RANGE
M11077
Adjustable Bath Step & Support Pillars
General Safety Warning
Please make sure that you read and follow these
instructions carefully. Keep these instructions in
a safe place for future reference.
Maximum User Weight
50st
317kg
1. INTENDED
USE
The NUVO Adjustable Bath-Step has been designed to assist users transferring into and out of the bath
by reducing the step-over height. It can also provide assistance when using the toilet or sink in a bathroom
environment.
2. SAFETY
WARNING:
The maximum user weight must not be
more than 317Kg (50st).
WARNING:
The maximum step height is 175mm
(7”) using 6 step sections (2 packs).
DO NOT:
Stack more than 6 step sections together.
ALWAYS:
Make sure the bottom section of the step
has 4 support pillars inserted into the base.
3. UNPACKING
Remove the packaging and check all parts carefully.
Contact your supplier immediately if parts are
missing or damaged and do not try and assemble.
3.1 Contents:
1. Step 50mm (2”) x 3
2. Support Pillar x 4
4. ASSEMBLY/INSTALLATION
4.1
Single Step - 50mm (2”) Step Height:
1. Turn one step section upside down and lay
fl
at.
2. Push the four support pillars into position (see
Figure 1).
Figure 1: Insert Support Pillars
3. Turn the step over to stand on the pillars and
place in the desired location.
4.2
Two Steps - 75mm (3”) Step Height:
1. Turn one step section upside down and lay
fl
at.
2. Push the four support pillars into position (see
Figure 1).
3. Place an additional step section on top of the
fi
rst.
4. Push
down
fi
rmly to secure.
4.3
Three Steps - 100mm (4”) Step Height:
1. Place an additional step section on top of the
top step section.
2. Push
down
fi
rmly to secure.
