1
USER INSTRUCTIONS
NRS ALUMINIUM SWIVEL BATH SEAT
N72838
NRS Aluminium Swivel Bath Seat
General Safety Warning
Please make sure that you read and follow these
instructions carefully. Keep these instructions in a
safe place for future reference.
Maximum User Weight
25st
160kg
1. INTENDED
USE
This Swivel Bath Seat is designed to enable a user of limited mobility to rotate, whilst seated, into the bath to allow
seated washing. It is suitable for most standard baths but is not suitable for corner baths, baths which have uneven
/ pro
fi
led top edges or some baths with deeply moulded side panels. The frame can be adjusted to
fi
t most common
bath sizes.
2. SPECIFICATION
Support Frame Width 660-760mm
Seat Width: 460mm
3. SAFETY
WARNING:
The maximum user weight must not be more
than 160Kg (25st).
CHECK
all
fi
xings are installed correctly.
MAKE SURE
when placing on the bath ensure all four
feet of the bath seat mounting frame are resting on the
edge of the bath by at least 50mm (2”).
CHECK
the Handwheel screws are contacting
either side of the bath wall. Do not over tighten the
handwheels as this could damage the bath.
DO NOT
exceed the maximum user weight limit.
ALWAYS
sit in the centre of the seat.
DO NOT
lean on the edges of the seat.
DO NOT
stand on the seat or any other part of the
product.
INSPECT
at regular intervals, see care and
maintenance section.
1
2
3
4
4. UNPACKING
Remove the packaging and check all parts carefully.
Contact your supplier immediately if parts are missing or
damaged and do not try and assemble.
4.1 Contents:
1.
Seat Assembly x 1
2.
Armrest x 2
3.
Mounting Frame x 2
4.
Fixing e-clips x 4
5.
User Instruction x 1
5. ASSEMBLY/INSTALLATION
Slide each armrest (A) into the locating tubes on the seat
assembly until the spring button clips “snap” into position,
see diagram 2
Slide the mounting frame (B) into the locating tubes on
the seat assembly, note the frame is width adjustable,
