User Instructions
NRS Wheeled Commode Range
Intended Use
The Wheeled Commode range is designed to be
used, either as a commode, or over the toilet. It
may be used for short transfers on even floor
surfaces to move the client over the toilet subject
to a suitable risk assessment. It is suitable for
less mobile clients.
The products feature; removable arms to allow
side transfers, detachable swing away footrests
and four brake castors. Model M66119 is also
height adjustable.
Limitations of use
Do not use as an alternative to a wheelchair.
Do not use in the shower/ as a shower chair.
Do not use to transfer clients over raised
thresholds.
The commode should only be used indoors.
If you have any doubts about the restrictions on
use, please contact NRS (details on reverse).
General Safety Warning
Please ensure these instructions are fully
read and understood before installation/ use.
Retain these instructions in a safe place for
future reference.
Unpacking
Remove all items from the packaging, check all the
items listed below are present
(dependant on model type)
Check each component for any visible damage. If you
see any damage, or suspect a fault, do not assemble
the product; but contact your supplier immediately
Contents:
L22056
M66119
Qty.
Main Chassis (c/w Castors)
1
Main Chassis
1
Seat Cover
1
Detachable arms
2
Detachable back
1
Potty
1
Footrest
2
Adjustable Height Castors
4
Hand wheel
2
E - Clip
4
L22056 Shown
Assembly Instructions:
1 – M66119 Only
Fit the Adjustable height castors to the main
chassis, slide the tube to the desired height, and
check that all legs are equal in height. Secure
with the E-clips provided, making sure each clip is
fully connected.
Please note; the height should be set so the client
feels comfortable, but ensure there is adequate
clearance if being used over a toilet
2 – All models
Place the chassis on a level floor.
3
– At the rear of the commode there are two
black threaded hand wheels. Undo the hand
wheels so that the screw thread is clear from the
inside of the vertical tubes. Place the tubes of the
detachable back into the chassis tubes and
secure by turning the hand wheels until you feel
the resistance and the screw thread is biting
against the leg of the backrest.
Caution: DO NOT over tighten the hand
wheels. Do not use tools as it is only
necessary for the back to be secured finger
tight.
4 -
Place the two detachable arms into the
locating holes on either side of the seat moulding,
ensuring they are fully inserted and secure.
L22056 NRS Wheeled Commode
30st
190kg
M66119
NRS Wheeled Commode
Height Adjustable
25st
160kg
Maximum
User
Weight
