™
N
Ú
VELLI
M O B I L E L I F E S T Y L E E V O L U T I O N
NOTE: PLEASE READ ALL THIS INFORMATION BEFORE USING
THE NUV2815S/NUV2815B WIRELESS STEREO SPEAKER.
Important Information
13
Conformity Declaration
17
Important Information
14
8.
9.
10.
11.
12.
Some medical electronic equipment may not be
shielded from R F energy. Therefore, please
do not use the headphones near medical equipment
without permission.
Please turn off the NUV2815S/NUV2815B before
boarding any aircraft. To prevent any interference
with communication systems, please do not use
the transmitter while the plane is in the air.
Please turn off the NUV2815S/NUV2815B in any
area with a potentially explosive atmosphere.
Please do not allow children to play with the
NUV2815S/NUV2815B since it contains small parts.
Please do not expose the rechargeable battery
to extreme temperatures. If the battery is used at
low temperature , the battery capacity will be reduced.
1.
2.
3.
4.
5.
6.
7.
Check for any exceptions or rules, due to national/local
requirements or limitations, in usage of the NUV2815S/
NUV2815B or any other Bluetooth devices.
Please note that only authorized Núvelli manufacturers
or service partners should remove and/or replace the
rechargeable battery, or any other components.
Please use Núvelli original accessories only. Use of
non-Núvelli original accessories may result in damage,
loss of performance to the NUV2815S/NUV2815B, injury,
electric shock or even fire.
Please do not expose the NUV2815S/NUV2815B to
extreme high or low temperatures, moisture or fluid.
Please do not drop, throw or bend the NUV2815S/
NUV2815B as rough treatment will damage them.
If the NUV2815S/NUV2815B will not be used for a while,
please store them in a place where it is dry, free from
dust, and not prone to extreme temperature fluctuations.
RF frequency and energy may affect some electronic
systems in a motor vehicle. Please check with the
manufacturer to ensure that the NUV2815S/NUV2815B
will not affect the electronic systems in the motor vehicle.
2.
3.
4.
5.
Press and hold the MFC in for about 6 seconds, until
the red and blue LEDs flash alternately. The NUV2815S/
NUV2815B will now be in Pairing mode.
Initiate the Bluetooth search function in your other
Bluetooth devices Please refer to the user's manual of
the cellphone for more information.
Select “NUV2815S/NUV2815B” in the device list on the
phone and follow the instructions to proceed.
Follow the instruction to enter the pairing code “0000”.
The red LED indicator will stop flashing if pairing is
successful. The NUV2815S/NUV2815B device ID will be
stored in the device list of the phone so that no
pairing will be required for the next use.
Operating Instructions
8
LOW-POWER PROMPT
The red LED will flash when the power level is low.
Please recharge the unit.
Operating Instructions
10
Status
MFC
Press and
hold
Press
briefly
Power on
(around
4 secs)
Enter
pairing
mode
(around
6 secs)
Power
Off
N/A
Standby
Voice
activated
dial
Power off
(around
2 secs)
Cancel
pairing
Pairing
Power off
Cancel
Voice
Command
Voice
Command
Power off
Reject call
Answer
call
Incoming
call
During a
call
End call
Power off
CONTROL OVERVIEW
The voice command and function only works with
cellphones that support this function.
Note: Some cellphones may not support some or all
of the above functions. Please refer to the user’s
manual of your cellphone for more information.
User
’
s Guide
NUV2815S l NUV2815B
4
Welcome
Index
1
Index
1
Diagram
Welcome
Operating Instructions
-- example
-- power on/off
-- pairing
-- volume adjustment
-- playing stereo music
-- answering/ending phone calls
-- control overview
-- low-power prompt
Package contents
Important information
Specifications
Conformity Declaration
3
4
5 - 12
5
12
6
7
8
9
9
10,11
17
2
13,14
16
-- pairing with other Bluetooth devices
11
Package Contents
2
-- charging
6
Glossary
15
A2DP: ADVANCED AUDIO
DISTRIBUTION PROFILE
AVRCP: AUDIO / VIDEO REMOTE
CONTROL PROFILE
This converts normal audio files, such as
MP3 files in a cellphone or a computer, into
streaming stereo music. Many new mobile
electronic devices are being made with this
feature built-in.
This feature allows the user to control the
output of one device from a remote device.
For example, if you are listening to music on
your NUV2815S/NUV2815B from your cellphone,
you can control the functions of the cellphone by
using the NUV2815S/NUV2815B controls for
volume, call transfer, etc
Glossary
15
16
Specifications
-- line in function
12
Diagram
3
DC jack
LED indicator
Front
Back
Multi-function Control
Vol
+
Vol
-
Microphone
LINE in
Operating Instructions
9
STEREO MUSIC
After pairing with a Bluetooth device that supports
the A2DP profile, such as a PC or a cellphone, the
music output of those devices will be transmitted to
the NUV2815S/NUV2815B and the music play can be
controlled from the NUV2815S/NUV2815B (please refer
to the attached control overview).
VOLUME ADJUSTMENT
At any time during a phone call, or while playing
music, the volume can be changed with the Vol+
or Vol- control ring.
ANSWERING/ENDING PHONE CALLS
If you are playing music from the cellphone, the
music play will be paused when there is an incoming
call. A beep tone will also be heard to notify that there
is an incoming call. Press the MFC once to answer
the call and press it once again to end the call. When
the call is ended, the music play will be automatically
resumed.
Vol
+
Vol
-
Operating Instructions
12
B. PAIRING WITH A BLUETOOTH AUDIO ADAPTER
1. Refer to the pairing procedure (1 & 2) shown on page 6.
2. Initiate the pairing function of the Bluetooth audio
adapter. Please refer to the user's manual of the
adapter for more information.
3. The red LED indicator on NUV2815S/NUV2815B will stop
flashing when pairing is successful.
CHARGING
With the accessory charging cable, connect the
NUV2815S/NUV2815B to the USB port of any PC,
laptop, or AC/DC adapter. The red LED will indicate
when charging has begun and will go off
when completed.
Note: Be sure to charge the unit for at least 2.5
hours before the first use.
POWER ON/OFF
Press and hold the MFC inward for about 4
seconds (see diagram) until the blue indicator
flashes and there is a tone from the speakers.
The unit will now be in Standby mode. Press and
hold inward for 2 seconds until the red light
flashes and there is another tone from the
speakers. The unit will now be off..
Note: The NUV2815S/NUV2815B needs to be paired
with another Bluetooth source before it can transmit
voice or music.
Operating Instructions
6
About 6 Seconds
PAIRING
"Pairing" means creating a trusted relationship between
two or more Bluetooth devices. The devices must be
paired before they can communicate with each other.
Pairing identification is stored for later use, and the
devices will automatically recognize each other the
next time they are connected. The NUV2815S/NUV2815B
will store up to 7 device IDs in memory, although it can
only connect to one device at a time.
Note: Make sure the NUV2815S/NUV2815B is “off” before
starting the Pairing procedure
.
How to pair with cellphones
1. Place the NUV2815S/NUV2815B within 1 foot of the
device to be paired with.
Operating Instructions
7
1 Foot
About 6 Seconds
Code: 0000
PAIRING WITH OTHER BLUETOOTH DEVICES
A. PAIRING WITH A BLUETOOTH ENABLED PDA,
CELLPHONE, LAPTOP, TABLET. ETC.
1. Refer to the pairing procedure (1 & 2) shown
on page 8.
2. Initiate the Bluetooth search function on the PDA.
Please refer to the user's manual of the PDA for
more information.
3. Select “NUV2815S/NUV2815B” in the device list on the
PDA and follow the instructions to proceed. The pairing
code is “0000”.
11
Status
Play
Standby
Pause
The functions below only apply to devices supporting
the A2DP / AVRCP profile. Consult the user's manual
for more information. Here is the control overview for
playing stereo music.
Press and
hold
Press
briefly
Play
Power off
Power off
Power off
Pause
Play
Operating Instructions
CONTROL OVERVIEW
MFC
5
Operating Instructions
Bluetooth
mobile phone
Bluetooth
enabled PDA
USB Bluetooth
Stereo Dongle
with 3.5mm Jack
EXAMPLE
1
2
3
4
5
6
7
8
9
0
*
#
1
2
3
4
5
6
7
8
9
0
*
#
Bluetooth version: Bluetooth v2.1+EDR, class 2
Working range: Max 10m
Frequency range: 2.4 ~ 2.48 GHz
Support profile: HFP, HSP, A2DP, AVRCP
Power supply: Built in li-ion rechargable battery
Talk time: about 9 hours
Music playing time: about 8 hours
Speaker output Power: 2 W X 2
Frequency response: 20Hz~20KHz
Product size: 40x40x160mm
Product weight: 170g
Operation temperature: -10˚C ~ + 55˚C
LINE-IN
When connecting the NUV2815S/NUV2815B to another music
source via the 3.5mm jack, the Bluetooth function will be
cancelled. The NUV2815S/NUV2815B will not operate as a
handsfree device.
Note: In order to save power,please unplug the audio cable
when not in use.
Main unit
User's Guide
Use
r's
guid
e
Audio Cable
USB Charging
Cable
Carrying bag
For more information, visit nuvelli.com
Note: Images of accessories are for reference only. ©2012 Alpha
Comm Enterprises, Inc. All rights reserved. All brand names and
trademarks are property of their respective owners.
Manufactured and Distributed exclusively under license by:
SO
Ú
ND
CYLINDER
™
B L U E T O O T H V . 2 . 1 + E D R T E C H N O L O G Y
®
B L U E T O O T H
S T E R E O S P E A K E R
®
®
®
NÚVELLI
Stereo Spe
aker
mic
®
®
NÚVELLI
Stereo Speaker
mic
®
®
NÚVELLI
Stereo Speaker
mic
Thank you for your purchase of our NUV2815S/
NUV2815B Wireless Stereo/Speakerphone. This User's
Guide will help you to learn the basic features. Please
read it carefully before using.
You will find the NUV2815S/NUV2815B to be convenient,
compact and easy to use. It’s both a handsfree
speakerphone with built-in DSP microphone, and a
streaming stereo music player. It can connect wirelessly
to almost any Bluetooth device, or by wire to any music
source with a 3.5 mm jack. Please note that your
Bluetooth music source must be able to transmit A2DP
stereo - if not, you may need an Bluetooth audio
transmiter. If you’re not familiar with some of the
technical terms in this Guide, please consult the glossary
on page 15.
FCC:
This device complies with part 15 of the FCC
rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesiredoperation.
CE:
Alpha Comm Enterprises,Inc. declare under our
sole responsibility that our product Núvelli
Wireless Stereo Speakerphone
NUV2815S/NUV2815B and in combination
with our accessories, to which this declaration
relates, is in conformity with the appropriate
standards, EN 301489,EN 300328, and EN 60950,
following the provisions of Radio Equipment.
Telecommunication Terminal Equipment
directive 99/5/EC, with requirments covering
EMC directive 89/336/eec, and Low Voltage
directive 73/23/EEC.
ROHS:
This product is fully compliant with the ROHS
Directive 2002/95/EC.
WEEE:
This product is fully products are fully
compliant with the WEEE Directive
2002/96/EC.
iPad & other tablets
