New Instruction Manual for 53306
1.)
Open the panel to the coin mechanism with the supplied Key.
2.)
Note the red plastic coin that is held by the mechanism.
3.)
Slide back the holding mechanism and remove the red plastic coin.
4.)
Insert a reference coin where the red plastic coin was before. The mechanism will then only
allow coins of the same kind.
The coin has to have a diameter 20 – 30 mm, and a thickness from 1.2 – 3.0 mm:
50
Underneath the coin mechanism, there is a loose cable to connect a power supply. There is
also an LCD number display and a keypad with 4 buttons:
UP
BACK CONFIRM
DOWN
5.)
Connect a power supply or the supplied battery. The mechanism will beep.
6.)
After connecting the power supply, the LCD display will show
Pn01
for about 15 seconds. To
change any settings, press the
UP
or
DOWN
button. If no button is pressed after 15 seconds,
the display will show
END
and lock the current settings. Disconnect and Reconnect the power
supply to restart the process, if you want to change the settings again.
