One for All URC 8090, User Manual

INSTALLING THE BATTERIES

Your 

Home Producer 8 requires four (4) new AAA

alkaline batteries.  To install the batteries:

1

On the back of the 

Home Producer

8, press down on the black battery
cover near the indentation where
the black and silver sections meet
and push/slide the cover off (see
illustration).

2

Match the + and - marks on the
batteries to the + and - marks in the
battery case, then insert the
batteries.

3

Slide the battery cover back into
place.

4

Test the unit by pressing POWER.
If the batteries are inserted correctly,
the red light will blink.

NOTE: Immediately before removing the batteries, please refer to
page 8 and re-enter your TV's setup code.  This will allow the Home
Producer 8 to retain its memory upon removing the batteries.  If you
do not, upon entering your fresh batteries, the LCD screen may say
[MEM FAULT].  If [MEM FAULT] does appear on the LCD screen,
press and hold MAGIC until the display screen changes from [TV and
the TIME] to [TIMED SEQ].  Press the MENU - key one time.  The
display screen will change to [CODE SET UP].  Press SELECT.  The
display will change to [DEV SET UP].  Press SELECT and the display
screen will change to [TV].  Enter code 9-6-1.  Press SELECT.  Now
press and hold MAGIC until the display screen changes from [TV and
the TIME] to [TIMED SEQ].  Press the MENU + key one time.  The
display screen will change to [CONFIGURE].  Press SELECT.  The
display screen will change to [THEATR SEL].  Press MENU + once.
The display screen will change to [SERVICE].  Press SELECT.  The
display screen will change to [MFG RESET].  Press SELECT.  The
display screen will change to [SEL TO RS].  Press SELECT.  The
display screen will then return to [TV and the TIME].

POWER

URC 8090

Home Producer

User Manual