ST 6100 Terminal Installation Guide
R9015 Version 03
1
© ORBCOMM
®
Proprietary
ST 6100 terminals are integrated IsatData Pro communications terminals manufactured by ORBCOMM.
ORBCOMM distributes the terminals through Solution Providers who activate the terminal on the IsatData Pro
network. The terminals are available with side or bottom connectors.
This guide provides information required for a successful, reliable installation of the terminal on a vehicle, boat or
other platform. This guide does not address the terminal’s commissioning procedures as these procedures vary
depending upon the Solution Provider and their specific application.
View of ST 6100 side connector
Required Tools
Installation of the terminal requires the following tools:
•
Drill and 5.5 mm drill bit
•
30 mm diameter hole punch or hole saw (bottom connector version only)
•
Screwdriver
•
Socket wrench set
Required Materials
Installing a terminal requires the following recommended materials. These materials do not ship with the
terminal because they differ for each installation.
•
Qty 4 - M4 (8-32) 18-8 stainless steel screws (length depends on mounting surface thickness)
•
Qty 4 - M4 (8-32) nuts with 18-8 stainless steel flat and lock washers
•
Waterproof sealing tape
•
Dielectric grease
•
Qty 1 - Custom cable provided by your Solution Provider
•
Mating connector kit (ST100030-001)
Cable
The Solution Provider may provide a custom cable to connect to the terminal. Contact your Solution Provider if
you did not receive a cable.
Record the Mobile ID
Each terminal has a unique serial number, termed a mobile ID, used by ORBCOMM to register it on the IsatData
Pro network. This is a 15-digit alphanumeric identifier in the format "NNNNNNNNSKYXXXX" The mobile ID is
located on the bottom of the terminal and on the shipping box. Record this number before the terminal is
mounted. You need it later for commissioning the terminal on the network.
Installation Steps
CAUTION
Most users install the terminals on a vehicle. It is very important for installers to
install the terminals in a safe and secure way to avoid danger or damage to
persons or property.
Select the Mounting Location
•
Mount the terminal where it has a clear view of the sky/satellite. For a mobile installation, this means that
it is preferable to install at the highest point on the vehicle or vessel where it has a clear view of the sky in
all directions.