background image

Portable Pleat

Instruction Manual

Wall Light

Safety & Installation Instructions

Other Important Information

Switch off at mains before changing lamp(s). Never fit a lamp of greater wattage than recommended. Ensure children do not 
play with the light fitting. If the fitting is to be positioned in an area which can be accessed by young children we recommend 
installing the light with a suitable cable clip to prevent the flex from becoming a choking hazard. These are available at good 
hardware stores. Dispose of old lamps carefully. Never leave a fitting without a lamp in position (or someone can accidently 
touch the contacts). Adjust fitting only when power to the fitting is off and has been left to cool. If the electrical flex or 
electrical components become damaged at any point, power to the fitting should be disconnected immediately and not operated 
until the damaged parts are fixed/replaced. For use in a dry, indoor environment only. Ensure the fitting does not come into 
contact with any liquids. 

Cleaning and Maintenance

Metal finishes should only be cleaned with a soft, dry cloth. Do not use polishes or abrasives. Bone china can be cleaned by 
hand, using a soft damp cloth with a diluted mild detergent (nonabrasive) if necessary. Switch off power to the fitting before 
cleaning.

MADE IN BRITAIN

ORIGINALBTC.COM

+44 (0)1993 882 251

UNIT 21 / 22 AVENUE ONE, STATION LANE, WITNEY, OX28 4XZ, ENGLAND

Established in 1990, Original BTC manufactures relaxed, familiar lighting for traditional and contemporary homes. 

All products are hand-assembled in Oxford from high quality components, produced in the UK. 

v1.1-04.19

These instructions are provided for your safety in order to prevent the risk of Fire, Electric shock or Injury. It is vitally 

important that they are read in their entirety before installing your fitting. Please retain for future reference.

1.    If you are in any doubt consult a qualified electrician as to the installation of the fitting. Install in accordance with current 
       IEE wiring regulations. It is recommended that this fitting is installed by a qualified electrician.
2.    Carefully identify where the supply cable is (and check there are no other cables in the area) to avoid damage to concealed 
       wiring during installation.
3.    Position the light where desired ensuring that there is suitable support adjacent to where you will connect to the house 
       supply and mark position of fixing holes, before drilling appropriate holes as below.
4.    a. Brick or masonry: Drill holes into which the wall plugs tightly fit, then insert wall plugs.
       b. Wood: No hole necessary (unless small pilot hole required), screws can be screwed directly into the timber.
       c. Plaster/Cavity: Special cavity wall fittings are required, rather than provided fixings. These are widely available from 
           good hardware or DIY store and should come with their own instructions that must be followed. It may be easier to 
           relocate the fitting so that you screw directly into a timber joist or beam.
5.  Fit the correct type and wattage of lamp (or less). Be careful not to overtighten the lamp.
6.  Switch on at the fuse-board. Your light fitting is now ready for use.

Reviews: