CONGRATULATIONS!
You’ve purchased the finest in natural lighting technology
with your new OttLite
®
product.
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and return it today by
mail, or register online by going to: OttLite.com/warranty
WARNING:
To prevent electric shock, make sure the lamp is not plugged in until
all steps are complete.
NOTE:
This product can be used as a desk light, a clip-on light, and as a portable
handheld light.
LIGHT OPERATION
1.
Fully charge light before use. Connect the USB-C cable (A) to the USB-C port
(B) on light and to a 5V / 1A standard USB power source such as a laptop
computer or adapter (not included). Red light (C) on the light indicates charging.
The red light will turn green when battery is fully charged. Once charging is
complete, disconnect the USB-C cable.
2.
To turn the light “ON” to 1st brightness setting; touch the switch (D) “once”.
3.
For 2nd brightness setting; touch the switch “two-times”.
4.
For 3rd brightness setting; touch the switch “three-times”.
5.
To turn light “OFF”; touch the switch “four-times”.
PLEASE NOTE:
This light will function while the USB-C charging cable is plugged
into a power source OR on its own internal battery. When using on battery power
and the light starts to dim, this indicates that the internal battery needs to be
recharged.
ASSEMBLY FOR DESK LIGHT USE
1.
Unpack all parts and screw the pole (E) into the base (F).
2.
The light assembly has a magnet in the base (G) that attaches to the metal ball
(H) at the top of the pole (E).
3.
Adjust the light angle to the desired position for use.
FOR CLIP-ON LIGHT USE
1.
Squeeze the clip (K) and attach to a suitable support such as a desk or shelf.
2.
Attach the light magnet (G) to the metal ball (L) on the clip.
3.
Adjust light angle to desired position for use.
SAFETY WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS
1.
Turn lamp off and
WAIT UNTIL LAMP HEAD IS COOL
before handling.
2.
The LED panel (M) might get hot after several hours of continuous use
DO NOT
place your hands directly on LED light panel.
3.
The lamp head included with this unit cannot be replaced by the consumer.
4.
INDOOR USE ONLY.
NOTE:
The important safety instructions appearing in this instruction sheet are
not meant to cover all possible conditions and situations that may occur. It must
be understood that common sense, caution, and care must be used with any
electrical product.
CAUTION!
THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE; WHEN
THE LIGHT SOURCE REACHES ITS END OF LIFE THE WHOLE LUMINAIRE SHALL BE REPLACED.
CAUTION:
Any change or modification to product not expressly recognized by
OttLite Technologies voids OttLite’s responsibility for proper function of product.
FCC PART 15
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that the interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
CAN ICES-005 (B)/NMB-005 (B)
SPECIFICATIONS
USB: 5V, 1A / Input power: 5V, 1A
Battery: Lithium, 3.7V / 1200mAh (power for LED Light)
ACCESSORIES
• USB-C charging cable
ENGLISH
Switch 3-in-1 Rechargeable Task Lamp
B
A
Switch 3-in-1 Rechargeable Task Lamp
CSR07G5W-CA CSR07G5W-SHPR
SL9909
INS220686
REV032422
E
M
C
D
H
G
Li-ion Battery -
Capacity: 1200mAh. Output Voltage: 3.7V
NOTICE:
Never disassemble by yourself. Use the authorized charger only.
Exposure of battery to open flames could cause explosion.
Do not expose the battery pack out of the temperature range 32°F to
113°F (0°C~45°C)
MADE IN CHINA
F
K
L
B
C
