ENGLISH
CONGRATULATIONS!
You’ve purchased the finest in
natural lighting technology with your
new OttLite
®
product.
STEP 1: PRODUCT
REGISTRATION FORM
Please complete the enclosed
Product Registration Form and return
it today by mail, or register online by
going to: www.ott-lite.com/warranty.
WARNING: To prevent electric
shock, make sure the lamp is not
plugged in until all assembly steps
are complete.
STEP 2: LAMP ASSEMBLY
1. To adjust the tension of the side-to-
side motion of the lamp head, use a
coin to turn the screw (A).
2. To adjust the tension of the up-
and-down motion of the lamp head,
use a coin to turn the screw (B).
3. It should not be necessary to
make adjustments to part (C), as
the tension has been preset at the
factory. However, if you find that the
neck of the lamp is too loose, use a
coin to turn the screw (C) clockwise
to tighten the arm tension.
STEP 3: TUBE INSERTION/
REPLACEMENT
1. Make sure the lamp is not plugged
into an electrical socket.
2. If the lamp has been in use,
allow it to cool for approximately
5 minutes before proceeding.
3. Set the lamp upright on a flat
surface.
4. Rotate the shade (D) so that the
notch (E) in the base of the shade is
positioned over the tab (F) located on
the socket assembly (G). Refer to the
diagram for proper shade position.
5. Remove the shade by pulling it
straight out from the socket assembly.
6. To install a tube (H) in the socket,
grasp the tube firmly in your hand,
position the tube so that it is aligned
as pictured in the diagram, then push
the tube straight into the socket until
it “snaps” into place.
7. To remove a tube already installed
in the lamp, grasp it firmly in your
hand and pull it straight out of the
socket.
Do not twist or turn the
tube while removing it from the
socket.
8. To replace the shade, position it as
indicated in the diagram, then push it
back into the socket assembly mak-
ing sure the shade “snaps” into place.
9. Rotate the shade to the desired
position for use.
10. Plug the lamp into a standard
120V socket. Your lamp is ready
for use.
11. To turn lamp on or off, depress
rocker switch (I).
Please note that in operation,
OttLite
®
tubes are not dimmable.
Enjoy your OttLite
®
Executive
Desk Lamp!
This lighting system is designed
for use with OttLite
®
tubes
only (model number T13330 /
OLPL13TC). Use of other products
voids the warranty and may result
in damage to the lighting system.
CAUTION! IMPORTANT SAFETY INSTRUCTIONS:
THIS PORTABLE LAMP HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER) AS A FEATURE TO
REDUCE THE RISK OF ELECTRIC SHOCK. THIS PLUG WILL FIT IN A POLARIZED OUTLET ONLY ONE WAY. IF THE
PLUG DOES NOT FIT FULLY IN THE OUTLET, REVERSE THE PLUG. IF IT STILL DOES NOT FIT, CONTACT A
QUALIFIED ELECTRICIAN. NEVER USE WITH AN EXTENSION CORD UNLESS PLUG CAN BE FULLY INSERTED.
DO NOT ALTER THE PLUG.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT,
FULLY INSERT.
AVERTISSEMENT! IMPORTANTES DIRECTIVES DE
SÉCURITÉ:
CETTE LAMPE PORTATIVE EST MUNIE D’UNE FICHE POLARISÉE (UNE LAME PLUS LARGE QUE L’AUTRE). CE
DISPOSITIF DE SÉCURITÉ DIMINUE LE RISQUE DE CHOCS ÉLECTRIQUES PUISQUE LA FICHE NE S’INSÈRE DANS
LA PRISE QUE D’UN SEUL CÔTÉ. SI ELLE N’ENTRE PAS DANS LA PRISE, INVERSEZ-LA. SI ELLE N’ENTRE
TOUJOURS PAS, CONTACTEZ UN ÉLECTRICIEN QUALIFIÉ. N’UTILISEZ JAMAIS AVEC UNE RALLONGE SAUF SI
LA FICHE S’INSÈRE ENTIÈREMENT. NE MODIFIEZ PAS CE DISPOSITIF DE SÉCURITÉ.
AVERTISSEMENT:
POUR ÉVITER LES CHOCS ÉLECTRIQUE, INSÉREZ LE BOUT LARGE DE LA FICHE
DANS LA GRANDE FENTE ET POUSSEZ JUSQU’AU BOUT.
¡PRECAUCIÓN! INSTRUCCIONES DE SEGURIDAD IMPORTANTES:
ESTA LÁMPARA PORTÁTIL TIENE UN ENCHUFE POLARIZADO (UNA DE SUS PATAS ES MÁS ANCHA QUE LA OTRA)
COMO CARACTERISTICA PARA REDUCIR EL RIESGO DE UNA DESCARGA ELÉCTRICA. ESTE ENCHUFE ENCAJARÁ EN
CUALQUIER TOMACORRIENTE POLARIZADO SOLO DE UNA MANERA. SI EL ENCHUFE NO CALZA COMPLETAMENTE
EN EL TOMACORRIENTE DÉLE LA VUELTA. SI AÚN NO ENCAJA, PÓNGASE EN CONTACTO CON UN ELECTRICISTA
CALIFICADO. NUNCA UTILICE UNA EXTENSIÓN A NO SER QUE EL ENCHUFE PUEDA SER TOTALMENTE
INSERTADO. NO ALTERE EL ENCHUFE.
PRECAUCIÓN:
PARA PREVENIR UNA DESCARGA ELÉCTRICA, HAGA COINCIDIR LA PATA ANCHA DEL
ENCHUFE CON LA RANURA ANCHA, INSERTE TOTALMENTE.
Executive Desk Lamp
CAUTION!
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer
or its service agent or a similar qualified person in order to avoid a hazard. Indoor use only.
INS80010 REV080608
13w Executive Desk Lamp
OTL13DWS
