Part Number 104373-102 05/2008
©2005 - 2008 Overland Storage, Inc.
Page 1 of 4
This document describes how to unpack and set up a new
NEO 8000 Library. This same information is also found in
the
Overland NEO 8000 Library User Guide
.
WARNING: Due to the weight and size of the library, it
is recommended that at least two people be involved
with the unpacking process.
CAUTION:
Read and become familiar with the entire
document before starting this unpacking procedure.
Steps performed out of sequence may cause damage to
the library which voids existing warranties.
NOTE: Retain all packaging materials in a protected place in
case the library needs to be shipped to a different location.
Tools Needed
These tools are required to unpack the library:
•
9/16” wrench
•
10” adjustable wrench
•
Level tool
•
Large flat-blade offset screwdriver
•
Box knife
•
#2 Phillips screwdriver
1.
Position
the shipping container on a level surface with
adequate clearance to work around it (
NOTE: The container pallet is labeled “RAMP SIDE” on each
corner of the removal side.
•
Allow at least 10 ft. (3.0m) of clearance on the
removal side of the container
•
Allow about 3 ft. (1.0m) of clearance around the other
three sides of the container
•
Allow at least 8 ft. (2.5m) of vertical clearance
Figure 1. Unpacking Space Requirements
NEO 8000™ Library
Important Unpacking
Instructions
Overview & Notes
Removing the Outer Carton
N
EO
-8
11
7`
Ramp (Front)
Floor
Allow at least 10 ft. (3.0m)
to remove the library
from the pallet.
Allow 3 ft.
(1.0m) around
the library
Allow 8 ft.
(2.5m) vertical
clearance
