10400518-001 Sep 2013
©2013 Overland Storage, Inc.
Page 1 of 4
*10400518-001*
SnapSAN
™
S1000 / SnapDisk
™
E1000
Chassis Replacement Instructions
This document describes how to replace the chassis that uses
the ACBEL power supply for either a SnapSAN S1000 storage
array or a SnapDisk E1000 expansion array from Overland
Storage.
IMPORTANT:
Replacement of
S1000
chassis is an offline
procedure requiring you to shutdown the array. Before you
replace the
S1000
chassis, make sure you have a good backup of
your data.
WARNING:
To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working
with the unit.
AVERTISSEMENT:
Pour réduire le risque de choc électrique
ou endommagement de l'équipement, retirez toujours les
cordons électriques en travaillant avec l'appareil.
CAUTION:
While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.
These instructions cover moving the key components such as
drive assemblies, power supply modules, and controllers from
the old chassis to the new one as part of the replacement
procedure.
Prepare the Unit
Disconnect and Power Off
1.
Power off the unit using a
normal shutdown
:
•
Front Panel Display:
Reset/Shutdown > Shutdown
.
•
Web Management Interface:
System Maintenance > Reboot and Shutdown >
Shutdown
.
2.
When the “System Shutdown” message is shown, move the
main power switch
to OFF (O).
3.
Disconnect the
power cords
from the power supplies.
4.
Disconnect all
data cables
from the unit.
Remove the Bezel
1.
Press the
release latch
toward the center.
2.
Swing the right side of the
latch side
out about 2 inches
(5cm).
3.
Move the entire bezel toward the latch side to release the
tab
from the opposite flange and remove the bezel.
4.
Set the
bezel
aside on a secure surface.
PSU Socket
PSU Socket
Main Power Switch
S1000
Front Panel Display
Latch
Tab
