![background image](http://html1.mh-extra.com/html/overland-storage/snapserver-xsr-40/snapserver-xsr-40_instructions_1662925001.webp)
10400557-002
©2014 Overland Storage, Inc.
Page 1 of 5
*10400557
002*
SnapServer
®
XSR 40
Optional Sliding Rail Kit Instructions
This document describes how to upgrade the standard fixed
brackets that come pre-installed on a new SnapServer XSR 40
from Overland Storage.
WARNING:
To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working
with the unit.
WARNUNG:
Um das Risiko eines elektrischen Schlags oder
Schäden am Gerät zu vermeiden, ziehen Sie stets den
Netzstecker, bevor Sie an der Einheit arbeiten.
AVERTISSEMENT:
Pour réduire le risque de choc électrique
ou endommagement de l'équipement, retirez toujours les
cordons électriques en travaillant avec l'appareil.
CAUTION:
While working with the unit, observe standard
Electrostatic Discharge (ES10400557-002D) precautions to
prevent damage to micro-circuitry or static-sensitive devices.
Prepare the Unit
NOTE: If this is a new SnapServer that has not yet been installed
into a rack, go to the
Power Off and Disconnect
1.
Power off the unit by pressing the
Power
button on the
front of the unit.
2.
When all the LEDs are off, disconnect the
power cord
.
3.
Disconnect all
data cables
from the unit.
Remove the Bezel
1.
Carefully take hold of the front bezel by the right and left
flanges and pull straight out from the appliance until the
retaining clips release.
2.
Set the bezel aside on a secure surface.
Power Socket
Data Cables
Graphic Nee
ded
Pull
Pull