Cylinder Mate P/N CM6000 INSTALLATION INSTRUCTIONS
P
ERFORMANCE
A
DVANTAGE
C
OMPANY 4-3-17
CAUTION
To avoid the risk of personal injury, property damage or product damage, please use the included
fasteners for mounting.
* This product must be securely mounted to a stable surface and material.
* This product contains enough mounting hardware to assemble two Cylinder Mates to each other.
* Misuse of this product may result damage or injury and void warranty.
* Verify that all fasteners have been tightened securely before putting into service.
* Note: All included fasteners may not be utilized for every installation.
Items Required for this step Qty
For additional assistance call (888)-514-0083 between 8AM-5PM EST or email: info@pactoolmounts.com
page1
Option 1: Single Cylinder Mate CM6000 Mounting
Position Cylinder Mate in desired location with the non-windowed side on the primary
mounting surface. (see
Figure 1A
) Using the included hardware, attach the cylinder mate with (4) Carriage
Bolts P/N 2037 and (4) Nuts P/N 2042 to the mounting surface. Installer to locate and drill (17/64) holes for
mounting.
PAC Fastener
Kit
P/N 7037
not
included
¼-20 x ¾
Carriage Bolt
P/N 2037
FIGURE 1A
4
4
¼-20 Flanged Nut
P/N 2042
Small 7/16
ratcheting Wrench
(STANDARD VERSION)
INS-CM6000
www.pactoolmounts.com
Remove the attaching screw and replace strap.
The CM6000 Cylinder Mate can accept P/N CM-
20 strap.
Contact a PAC representative for more
information.
CM-20 Locking
Strap
Strap Mounting Screw
FIGURE 1B
