background image

INSTALLATION GUIDE

FSTA/2 Series LED Roadway Lights

Instructions and specifi cations are subject to change at any time without notice.  Copyright© 2023 PacLights   All Rights Reserved 

Page 1 of 2

Need help?  (800) 988 -6386   Email:  CS@PacLights.com  Website:  www.PacLights.com 

PL_INST_FSTA/2_v0

FSTA/2 INITIAL SET-UP

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE.  RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes.  Proper grounding is required for safety.  
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR 
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

WARNINGS:
• 

Make certain power is OFF before installing or maintaining fi xture.  No user serviceable parts inside.

• 

To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.

CAUTION:
• 

For  proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened fi rmly.  Apply weatherproof silicone 
sealant around the edge of the Back Box and/or Junction Box.  This is especially important with an uneven wall surface.  Silicone all plugs and 
unused conduit entries.

FIG. 1

OPTIONAL PHOTOCONTROL SENSOR

FIG. 2

                       FSTA/2-L/M/H 

 

 

 

 

 

 

FSTA/2-X

Install the Short-Cap on the Receptacle correctly by pressing down and 
twisting CW (Fig. 1).  Note: If Photocontrol Sensor is provided see the 
following for instructions.

Connect the ACL and the ACN from the FSTA/2 fi xture to the conduit with the AC power Supply Cable.  Follow the Wiring Diagram provided.

AC POWER SUPPLY

FSTA/2 DRIVER

GRAY (-)

PINK (+)

HOT [BLACK]

NEUTRAL [WHITE]

GROUND [GREEN]

WIRING DIAGRAM

DIM

INPUT

SHORT-CAP

There are two types of Twist-Lock Photocontrol Sensors available.  One 
of the Photocontrol Sensors has a Dusk to Dawn functionality.  Both 
Photocontrol Sensors can be easily installed on all FSTA/2 fi xtures as shown 
below.  Install the Photocontrol Sensor on the Receptacle correctly by 
pressing down and twisting CW (Fig. 2).  Note: If the Photocontrol Sensor 
is not included the following step can be skipped.  If the Photocontrol 
Sensor is included prior to fi eld installation, Initial Set-Up can be skipped.

PHOTOCONTROL 
        SENSOR

FSTA/2 FIXTURE

RECEPTACLE

Reviews: