Thank you for choosing a Panasonic Beard/Hair Trimmer.
Please read all instructions before use.
Important
Cautions for charging
Dry the appliance completely before charging it.
Do not use any power cord or AC adaptor other than this AC
adaptor (RE9‑36).
Charge the appliance at temperatures between 5 °C and 35 °C
where it will not be exposed to direct sunlight or other heat
sources.
The appliance may become warm during operation and charging.
This is normal.
Charge the trimmer for at least 16 hours when charging it for the
first time or when it has not been used for more than 6 months.
ER2201
Charge the trimmer for at least 8 hours when charging it for the
first time or when it has not been used for more than 6 months.
ER2211
The supply cord cannot be replaced. If the cord is damaged, the
appliance should be scrapped.
Cautions for use and storage
This trimmer has a built‑in rechargeable battery. Do not throw into
fire, apply heat, or charge, use, or leave in a high temperature
environment.
Turn off the appliance before changing the trimming length or
removing the comb attachment.
Before each use, apply oil at the places marked with arrows. (See
page 6.)
►
•
•
•
•
•
•
•
►
•
•
•
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
Moving parts should not be tampered with.
Do not pick up the appliance by the cord. It may become
detached, causing damage or injury.
The appliance should not be used with animals.
The appliance should not be disassembled. Take it to a qualified
serviceperson when service or repair is required.
The appliance should be stored in a place that is not exposed to
direct sunlight or near a heater or other source of heat.
Keep the AC adaptor away from water and handle it only with dry
hands.
Store the AC adaptor in a dry area where it is protected from
damage.
Check that the blades and the attachments are not damaged
before use. Replace them if they are damaged.
You should not allow permanent wave lotion, hair restorer or hair
spray to come into contact with the main body or the blades.
Doing so may result in cracking, discoloring or corrosion.
You should not drop the trimmer on the floor.
You should not knock the blades and the attachments against
hard objects.
Cautions for cleaning
Warning
Disconnect the power cord from the clipper before cleaning
it in water to prevent electric shock.
The housing should not be taken apart as this can affect the
watertight construction of the appliance.
•
•
•
•
•
•
•
•
•
•
•
•
►
•
Wash the appliance in tap water. Salt water, boiling water and
cleaning products that are designed for toilets, bathrooms or
kitchen appliances should not be used. The appliance should be
submerged in tap water for a short time only.
Clean the housing only with a soft cloth slightly dampened with
tap water or soapy tap water. Caustic cleaners such as benzine
or bleach should not be used.
Specifications
Power source: See the name plate on the product.
(Automatic voltage conversion)
Motor voltage: 1.2 V DC
Charging time: 8 hours
ER2201
1 hour
ER2211
This product is intended for household use only.
•
•
Parts identification
A
Main body
1
Trimming length indicator
2
Power switch
[0·CHARGE/1]
3
Dial
4
Charge indicator lamp
ER2201
Charge status lamp
ER2211
5
Finishing blade of Mini
trimmer
6
Trimmer guide of Mini
trimmer
B
Blade block
7
Stationary blade
8
Moving blade
9
Cleaning lever
:
Mounting hook
C
Comb attachment for beard
ER2211
Less mess comb attachment
prevents your beard‑trimmings
from scattering.
D
Comb attachment for beard
and hair
ER2201
ER2211
E
AC adaptor (RE9‑36)
;
Power cord
Appliance plug
F
Oil
G
Cleaning brush
H
Pouch
Operating Instructions
(Household)
AC/Rechargeable Beard/Hair Trimmer
Model No. ER2201/ER2211
Before operating this unit, please read these instructions completely and save them for future use.
2
3
F
EN
Printed in China
0000000000 X0000‑0
Panasonic Electric Works Wanbao (Guangzhou) Co., Ltd.
http://panasonic.net
