background image

Installation Guide for DECT Repeater

By installing this unit, you can extend the range of your phone system to include areas where 
reception was previously not available. 
The unit extends the range in all directions, allowing several floors to be covered.

Important:

L

This unit is an accessory unit for use with Panasonic Digital Cordless phones.

L

This unit is pre-registered to the base unit.

L

This leaflet only describes the steps needed to install and use the unit. Refer to the base unit’s 
operating instructions for accessory information, important information for safety.

For best performance

Placement

L

Install the unit within base unit range in an indoor environment. We recommend installing the 
unit in a raised position (such as on a wall).

L

Avoid positioning the unit close to objects that will interfere with reception, such as thick walls, 
radiators, metal shelving, etc.

L

For maximum distance noise-free operation, place the unit away from electrical appliances 
such as TV, radio, personal computer, or other telephone equipment.

L

Keep an appropriate distance from the base unit to maximise the range of your phone system. 
Find the appropriate location by checking the 

w

 indicator. If the 

w

 indicator lights red or amber, 

re-position this unit in a place where the 

w

 indicator lights green.

Model No.

DECT Repeater

KX-TGA405EX

Base unit

Handset

DECT repeater

DECT repeater range

Base unit range

PNQW3522ZA    

TT0912YK0  (A)

TGA405EX(en).fm  Page 1  Wednesday, August 22, 2012  10:39 AM

Summary of Contents for KX-TGA405EX

Page 1: ... unit range in an indoor environment We recommend installing the unit in a raised position such as on a wall L Avoid positioning the unit close to objects that will interfere with reception such as thick walls radiators metal shelving etc L For maximum distance noise free operation place the unit away from electrical appliances such as TV radio personal computer or other telephone equipment L Keep...

Page 2: ...sets are communicating with the base unit through this unit Red On L Out of base unit range Flashing L The unit is not registered to the base unit Off L The power is off AC adaptor is not connected properly w indicator Green On L Signal strength of the base unit is strong Amber On L Signal strength of the base unit is weak Red On L Out of base unit range Off L The unit is not being used L The powe...

Page 3: ...sconnected L The unit can support a maximum of 3 handsets at a time Wall Mounting Note L Make sure that the wall and the fixing method are strong enough to support the weight of the unit L Drive the screws not supplied into the wall Specifications N Standard DECT Digital Enhanced Cordless Telecommunications N Frequency range 1 88 GHz to 1 90 GHz N RF transmission power Approx 10 mW average power p...

Page 4: ... the indicator flashes green after releasing PROGRAM deregistration failed Deregister the unit again Re register 1 DECT repeater Unplug the AC adaptor 2 Base unit Press and hold x for about 5 seconds until the registration tone sounds L The next step must be completed within 90 seconds 3 DECT repeater Connect the AC adaptor then wait until the indicator and w indicator light green 4 Base unit To e...

Reviews: