PQQX13969ZA
F1003-0
D
Manufactured by Panasonic
Communications (Malaysia) Sdn. Bhd.
Senai Malaysia
For your future reference
Serial No.
(found on the bottom of the unit)
Date of purchase
Name and address of dealer
Integrated Telephone System
Operating Instructions
Model No.
KX-TS500HG
Pulse-or-tone dialing capability
PLEASE READ BEFORE USE AND SAVE.
KX-TS500HGW
This equipment is designed for use on
Hungary only.
In the event of problems, you should contact
your equipment supplier in the first instance.
1999/5/EC
1
Getting Started
1-A Location of controls
1-B Settings
2
ABC
3
DEF
1
5
JKL
6
MNO
4
GHI
8
TUV
9
WXYZ
7
PQRS
0
TONE
($)
Button (3-B)
(R)
Button
(3-A)
RINGER Selector
(1-B)
Button (2-A)
DIALING MODE Selector
(1-B)
VOLUME
(^)
,
(_)
Buttons (2-A)
R
1
Connect the telephone line cord (
1
).
2
Connect the handset cord (
2
), then confirm
the dial tone.
To Single-Line
Telephone Jack
Handset Cord
Handset
Telephone Line Cord
RINGER Selector
DIALING MODE
Selector
1
2
TONE
PULSE
DIALING MODE
HIGH
OFF
RINGER
3
Set the DIALING MODE selector to TONE.
≥
If you cannot dial, set to PULSE.
4
Set the RINGER selector to HIGH, LOW or
OFF.
(Ex. “LOW” is selected.)
∑
Handset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . one
∑
Handset Cord . . . . . . . . . . . . . . . . . . . . . . . . . one
∑
Telephone Line Cord . . . . . . . . . . . . . . . . . . . one
Accessories (included)
≥
When set to OFF, the unit will not ring.
2
Operation
2-A Making Calls
1
Lift the handset.
2
Dial a phone number.
≥
If you misdial, hang up and start again from
step 1.
3
When finished talking, hang up.
To redial the last number dialed
Lift the handset.
➡
Press .
To adjust the receiver volume (6 levels)
while talking
To increase, press
(^)
.
To decrease, press
(_)
.
≥
After hanging up, the volume level will be saved.
(\\\)
4
Things You Should Know
“
Things You Should Know
3
Special Features
3-A Recall Button
Pressing
(R)
allows you to use special features
of your host PBX such as transferring an
extension call or accessing special telephone
services (optional) such as call waiting.
2-B Answering Calls
1
When the unit rings, lift the handset.
2
When finished talking, hang up.
3-B Temporary Tone Dialing
(For Rotary or Pulse Service Users)
Press
($)
before entering access numbers
which require tone dialing.
≥
The dialing mode changes to tone. You can enter
numbers to access answering services, electronic
banking services, etc. When you hang up, the
mode will return to pulse.
≥
Access numbers entered after pressing
($)
will not
be included when redialing.
4-A Wall Mounting
To Single-Line
Telephone Jack
Screws
8.3 cm
Hooks
The unit can be mounted on a wall.
1
Press the tabs in the direction of the arrows
(
1
), then remove the wall mounting adaptor
(
2
).
3
Install screws using the wall template below.
Connect the telephone line cord. Mount the
unit, then slide down.
≥
Fasten the cord to prevent it from being
disconnected.
1
1
2
2
Tuck the telephone line cord inside the wall
mounting adaptor, and push it in the direction
of the arrow (
1
and
2
).
≥
The word “UP WALL” should face upward.
1
2
E̲PQQX13969ZA 03.10.10 2:43 PM ページ 1