E-mail:
techsupport@panduit.com
Technical Support:
1-800-777-3300
E
C
A
B
FIGURE 1
Page: 1 of 4
© Panduit Corp. 2018
INTRODUCTION
The BT2HTI Tool installs Panduit Pan-Steel coated and uncoated
IMS Series strap and buckles in widths of:
• 3/8” X .015” thick (9.5mm x 0.35mm thick)
• 1/2” X .015” thick (12 mm x 0.35mm thick)
• 5/8” X .015” thick (16mm x 0.35mm thick).
• 3/4” X .030” thick (19mm x 0.7mm thick)
The inverted blade provides longer cut-off lengths.
Note:
This tool is not intended for other uses such as cutting or
tensioning other types of fastening devices.
TOOL FEATURES
A. Rear Handle
B.* Tension Pawl Release - Knob pointing towards the front
of tool for pawl engagement and to rear of tool for disen-
gagement.
C.* Anti-Backup Pawl Release - Lever up against tool for
pawl engagement and pulled down to disengage pawl.
D.* Detent Lock Pins - For controlled tension, pull both pins
forward; for manual tension, push both pins backward.
E. Cutter Handle - Cuts tie when strap is tensioned properly.
F. Cutter Blade
G. Tensioning Mandrel
H.* Tension Indicator Window - Located on the back of front
handle.
I.* Adjustment Knob - Adjust tension of strap application.
J. Tension Locking Set Screw
K. Front Handle - With ratchet controlled tensioning.
* See Page 2 for Feature Detail
I
K
H
G
F
J
FIGURE 2
TOOL OPERATION
See Steps 1 - 8 on Pages 3 and 4.
D
PA28100A01
Rev: 02 6-2018
IMS STRAPPING TOOL OPERATION INSTRUCTIONS
BT2HTI
www.panduit.com
