For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2010
FS010
Opticom Fiber Wall Mount Enclosure
Part Numbers: FWME2, FWME4, FWME8
FWME8
FWME4
FWME2
1 - ENCLOSURE
2 - CABLE ENTRY GROMMETS
2 - STRAIN RELIEF BRACKETS
4 - BLACK CABLE TIES
1 - FIBER CAUTION LABEL
Contents:
1 - LASER WARNING LABEL
1 - FWMEHKIT
3 - #10-32 HEX NUTS
2 - #10-32 x 3/8" SCREWS
1 - FLAT WASHER
Parts included with all enclosures:
4 - BEVELED ENTRY CLIPS
2 - PORT I.D. LABELS
Additional parts included with
FWME4, FWME8 enclosures:
1 - BEVELED ENTRY CLIPS
1 - PORT I.D. LABELS
Additional parts included with
FWME2 enclosures:
Fiber Caution Label
Port I.D. Label
Laser Warning
Label
Assembly Instructions:
1. Determine the cable entry location on the enclosure.
Remove the knockout by inserting a screwdriver into the
slot located in the center of the knockout and applying a
twisting motion from the inside of the enclosure twisting
out. Insert grommet following proper cutting diagram.
Apply Laser Warning Label and Caution Label on the
inside of the larger door in a clearly visible location.
Apply Port I.D. Label(s) on the inside of the small door
(as shown).
Cut the small
circle for 1" dia.
innerduct
Cut the large
circle for 1-1/2"
dia. innerduct
Cut the straight lines
when not using any
innerduct
Grommet
Enclosure
