background image

Mounting Instructions 

WMMGG-7-27 

Introduction

The WMMGG-7-27 is a MiMo 2G/3G/4G antenna incorporating an integrated 

active GPS/GNSS antenna. 

SW3-687 - Document Version 1.0

Select Position

1.

For a good installation the antenna should be directed towards the strongest network signal. In order to achieve this follow the guide 

below.

a. 

Connect the antenna to your data card or modem with the antenna adapter and coaxial cable provided.

b.

 Ensure that your device is connected to the network and displaying the signal strength indicator.

c.

 With the antenna at selected location, rotate it in approximately 45 degree steps – in each position, you may need to wait for up to  

  one minute to allow the signal strength indicator to update.

Mounting the Antenna Externally

2.

Ensure that the selected mounting location can be safely accessed with the equipment that you have available and mount the antenna so that 

it has at least 1 metre (3.3’) of clearance from all obstructions if possible. The antenna should not be mounted directly on to metal walls or 

backing on to metal masts or poles. If the antenna must be mounted to such a surface it must be mounted at the lip of the roof or the very 

top of the pole such that the body of the antenna is elevated clear of the metal surface. To maintain GPS/GNSS performance the antenna 

should not be mounted under roof structures or overhangs.

Electrical Safety Note

This product contains an active GPS/GNSS antenna (part 

number SR8-HG26). Rated voltage: 3-5VDC rated current: 

20mA maximum. 

The supply to this device must be provided with overcurrent 

protection of 1A maximum.

Note

Signal strength indication may be displayed either: 

a.

 Graphically with bars, (where more bars is a better signal), or

b. 

As a signal level value in dBm (e.g. -80) - in this case,  the lower the negative number, the better the signal, (i.e. -71 is 

stronger signal than -83).

The GPS/GNSS antenna requires the antenna to maintain the correct vertical orientation (with cables at the base) and the antenna should 

be mounted so that the GPS/GNSS antenna located at the top of the antenna housing has a clear and un-obstructed view of the sky.

P A N O R A M A

A N T E N N A S

TOLERANCES UNLESS OTHERWISE STATED

1 DEC. PLACE

0 DEC. PLACE

2 DEC. PLACES
ANGULAR

±0.2

±0.5

±0.1

±1°

 155 

 31 

 15 

 155 

 70 
 92 

SMA PLUGS

TWIN CS29 LOW 

LOSS CABLE. 

5m LONG.

M6 FIXINGS VIA 

2 HOLES  7.0

ANTENNA HOUSING. 

WHITE LURAN 

S777K (A.S.A.).

UV STABILISED.

GPS/GNSS SMA 

PLUG 

6m RG174 

CABLE

 60 

 44 

50 NOMINAL

CLAMPING

POLE 

MOUNTING 

BRACKET

M6 'V' BOLT

 86 

 40 

 =70.0= 

 75 

 15 

 36 

ISO VIEW

SCALE 1:3

WALL MOUNT BRACKET

(SUPPLIED LOOSE)

PCN REV

DESCRIPTION

DATE

DRAWN

REVISIONS

01019

B

INITIAL ISSUE

18/02/2016

AR

THIS DOCUMENT MUST NOT BE COPIED OR 

DISCLOSED TO A THIRD PARTY WITHOUT THE 

WRITTEN CONSENT OF PANORAMA ANTENNAS LTD.

DRG.

No.

C

2016 A4

DO NOT

SCALE

 SCALE

 D.O.CHECK

 DESCRIPTION

 MATERIAL

 FINISH

DIMENSIONS

IN mm

1:3

IC

N/A

ELEVATED ANTENNAS

SHEET 1 OF 1

1000g

A

1

 WEIGHT

WMMGG-7-27-5SP

PROJECTION

DENOTES LATEST

ISSUE CHANGES

 PRODUCT/ASSEMBLY

JJ

APPROVED

M'BAND MIMO WALL MNT + GPS/GNSS

N/A

DENOTES CRITICAL 

VALUE

2

3

4

B

C

E

F

D

A. Mount the antenna

The antenna is supplied with weatherproof mounting hardware for wall or mast mounting and should be fitted with the cable entry at the 

bottom.

Mast Mounting

The clamp assembly allows fitting to masts of between 20-50mm 

(0.8” – 2”) diameter.

Reviews: