Turbine Series
900FH and 1000FH
Fuel Filter/Water Separators
Turbine Series filters protect
precision engine components
from dirt, rust, algae, asphaltines,
varnishes, and especially water,
which is prevalent in engine fuels.
They remove contaminants from
fuel using the following legendary
three stage process:
Stage 1 - Separation
As fuel enters the assembly, it
moves through the centrifuge and
spins off large solids and water
droplets, which are heavier than
fuel, and fall to the bottom of the
collection bowl.
Stage 2 - Coalescing
Small water droplets bead-up on
the surface of the conical baffle
and cartridge filter. When heavy
enough, they too fall to the bottom
of the collection bowl.
Stage 3 - Filtration
Proprietary Aquabloc
®
cartridge
filters repel water and remove
contaminants from fuel down to
2 micron (nominal). Aquabloc
cartridge filters are waterproof
and effective longer than water
absorbing filters.
Instruction Part Number 12960 Rev E
Contact Information
Parker Hannifin Corporation
Racor Division
P.O. Box 3208
3400 Finch Road
Modesto, CA 95353
phone 800 344 3286
209 521 7860
fax 209 529 3278
racor@parker.com
parker.com/racor
Getting Started
The following customer supplied
materials should be on-hand
before beginning installation.
•
Shop Towels
•
Diesel Fuel (about 1 gallon)
•
Thread Sealant (no thread
tapes)
•
Parker Super O-Lube
(RK 31605) or equivalent
•
Fuel Hose
•
Mounting Hardware (3/8˝
or M10 fasteners)
•
Inlet/Outlet Fittings
