Paxton Net2 Entry, Manual

Configuring a Net2 Entry Premium Monitor

Overview

Configuration - Setting the monitor ID

The Net2 Entry Premium monitor is an audio/video monitor used 
to remotely communicate with visitors, and is installed as part of a 
Net2 Entry system. It is powered using Power over Ethernet (PoE) 
and communicates with the other elements of the system using 
IPv6, providing ‘plug and play’ installation. 

The only configuration required is the allocation of a monitor ID 
which the system uses to identify the correct monitor.

If used in conjunction with Net2 access control software, this must 
be version 4.25 or later.

AN1172

Net2

When the monitor is first connected to the network it will not have a Monitor ID number.

The monitor ID is the number that a visitor will call to request entry (unless they are using a text only list) so it should relate to 
the location of the monitor where possible e.g. Flat Number.

From the menu, touch 

settings

 > 

engineer 

> enter the engineer code for the system (if required) > 

monitor id

, enter a Monitor 

ID number, then touch 

accept

.

Monitors sharing the same ID will all ring when a call is made to that ID, and some configuration (name, concierge, divert mode) 
will be common on all monitors.

1