background image

33

All holes in the hinge must be drilled correctly and 
properly installed

. Failure to will void the UL fi re 

rated listing.

Do not install Snap-On cover until installation is 
100% complete, and the assembly is correctly 
fastened and properly fi tted.

The Screw Pack contains self-drilling Tek screws. 
These screws are also recommended for grout-fi lled 
frames.

• Perform each step of these instructions.

(1) Place hinge on frame as shown in Figure 1 on 

the other side of these instructions. 

• Allow 1/8” between top of hinge and underside 
of header.
Note that at least 1 13/16” of frame face is 
required for mounting this hinge.

(2) Mark the position of the top and bottom 

adjustment holes with a center punch, then drill 
and fasten. The use of the PBB drill tool can help 
center the hole so that the fasteners will enter 
straight.

(3) After the top and bottom screws are installed, 

drill and fasten the remaining holes.

(4) Fold the door leaf back over the frame leaf and 

place the door in the door frame.

• Place shims under the door to provide 1/8” 
clearance between the header and the top of the 
door.
• Add shims at both the hinge and latch side of 
the door so that 1/8” clearance will be maintained 
equally on the lock side of the door.

(5) With the door held fi rmly in place, return the door 

leaf to the face of the door and repeat the drilling 
procedure described in steps (2) and (3). 

For Molly Jacknuts or Steel Sex Bolts or 
any other type  of fastening devices needed, 
Please contact PBB directly at 1-800-726-
3414.

(6) Remove all shims and wedges and make a 

gentle swing. Carefully check the door for proper 
swing and clearance.

(7) 

Install the Clip N-Go

 

Position the Molding so that the short leg is 
closest to the hinge pin. Hook the short leg 
over the Molding Clips along the full length 
of the hinge. Starting at the top and working 
downward press the long leg of the Molding in 
place completely over the outside edge of the 
door leaf. If necessary, gently tap in place using 
a rubber mallet, taking care not to damage the 
molding.-

Reviews: