Hella Horn Mount for 2015 WRX/STI
2014-11-25
Thank you for purchasing this PERRIN product for your car! Installation of this product should only be performed by persons experienced with installation of aftermarket performance parts
and proper operation of high performance vehicles. If vehicle needs to be raised off the ground for installation, the installer must use proper jacks, jack-stands and/or a professional vehicle
hoist for safety of the installer and to protect property. If the vehicle is lifted improperly, serious injury or death may occur! Please read through all instructions before performing any
portion of installation. If you have any questions, please contact our tech department prior to starting installation. We can be reached in any of the following methods:
Instant Chat off the main page of
Or simply call our tech team at 503-693-1702
Parts Included with the PERRIN Hella Horn Mount:
(1) PERRIN Horn Bracket
(2) M8 SS Washers
Installation of PERRIN Hella Horn Mount:
1)
Remove from bumper from car. Follow factory service manual for more detailed instructions:
a.
Locate and remove (6) black 10mm bolts and (2) plastic fasteners holding upper steel bracket to bumper.
b.
Locate and remove (1) plastic push-in fastener on each side bumper meets fender in wheel well.
c.
Locate and remove (9) plastic fasteners along bottom of bumper.
d.
Pull bumper outward on edges near fender well and work your way across front of car.
e.
Before pulling bumper completely off, unplug fog light connectors from chassis side harness.
2)
Using below picture for reference, locate radiator support bracket and remove 12mm bolt and plastic fastener.
