background image

6 Way Aerial Amplifier

with digital bypass

USER GUIDE

27823BMG

Ready

Introduction

Special features include:

 4G Ready - built-in filter removes interference and channel loss caused by 4G 

  mobile phone signals

 Dedicated inputs for UHF and FM/DAB

 Side mounted terminals provide easy cable management

 Infra-red by-pass for digilinks

Careline: 08457 573 479 - (Local Rate UK only) 

Support: www.philex.com/support

The SLxB series amplifiers are designed to improve the 
picture and sound quality of TV and FM radio signals 
and distribute these signals around your home. 

All SLxB amplifiers have an integrated by-pass 
designed to allow the user to control digital satellite 
receivers from a second TV without additional 
equipment apart fron a Link device and a digital 
satellite or compatible universal remote control.

Please Note: To view output from the satellite RF2 

output you will need a TV with an analogue tuner.

For added safety the SLxB series has built in short 
circuit protection
 on each individual output. Should 
a short circuit be detected the SLxB amplifier will only 
shut down the output with the short circuit; the other 
outputs will continue to function as normal.

The amplifiers are easy to install and fully automatic in 
operation, meaning that no user adjustment is required. 
The low running cost permits continuous operation.

Summary of Contents for 27823BMG

Page 1: ...xB amplifiers have an integrated by pass designed to allow the user to control digital satellite receivers from a second TV without additional equipment apart fron a Link device and a digital satellite or compatible universal remote control Please Note To view output from the satellite RF2 output you will need a TV with an analogue tuner For added safety the SLxB series has built in short circuit ...

Page 2: ...ket and connect your FM DAB aerial downlead if applicable to the IN FM socket on the amplifier 2 Connect your TVs and FM tuners to any of the SLxB TV sockets in any combination If your TV does not have a built in Freeview receiver you will need to connect your TV to the amplifier via a Freeview set top box ...

Page 3: ...te viewing Note Only one satellite channel can be viewed at any one time without the use of additional satellite receivers and subscriptions Note To operate your digital satellite receiver from one of the connected TVs you will now need to install a Link device such as the SLx Link Note To view digital terrestrial channels an aerial must be connected to the Aerial IN socket on the satellite Also c...

Page 4: ...y channels at all A weak digital signal can cause occasional blocking freezing or complete loss of picture Ensure that your aerial is a wideband high gain aerial suitable for DTT reception Blocking freezing or complete loss of picture can also occur when the signal is too strong If the signal is still too strong fit a signal attenuator between the aerial downlead and DTT receiver to reduce the sig...

Reviews: