Quick start guide
5766 series
Product design is for illustrative purposes only.
Actual product may vary.
Category
Problem
Tip
Power
No power
•
Ensure that the AC outlet supplies the proper voltage
.
Plug another electrical appliance into the AC outlet to
ensure that the AC outlet operates normally.
•
If a power failure occurs, unplug the AC power cord for
1 minute to allow the unit to reset itself.
Slow start up
Your TV takes a long
time to start up when
you turn it on.
•
When powering off the TV into Low Power Standby, there
will be a longer load time when powering it back on.
•
Press and hold the
(POWER)
button for 1 second
or more to go into Low Power Standby. Power
consumption in this mode will be reduced (
≤
0.5 W).
•
Pressing the
(POWER)
button for less than 1
second will put the TV into Quick Start Standby, which
will have a quicker boot time when powering back on.
Power consumption in this mode will be slightly higher.
For more details, please visit
www.philips.com/support
Remote
Remote buttons are not
functional.
•
Re-insert or replace the AAA batteries with their
polarities (+/–) as indicated on the remote battery area.
Google Assistant
microphone on the
remote does not work.
•
To pair the remote, refer to the step “7 Connecting
your devices” in the previous page and see “How to
connect to your Bluetooth® devices”.
To enable pairing mode, press the Google Assistant
button and vol down (-) button on your remote
simultaneously for 5 seconds.
Network
Cannot connect the
network.
•
Check if your router and/or modem is properly
connected.
•
Check if the Ethernet cable connection between the
TV and your router or modem is properly secured.
•
Power cycle the router and/or modem.
•
Check your network settings.
Slow Data Connection or
buffering.
•
Check the settings between your router and ISP
modem or gateway (if applicable).
•
Connect to a stable wireless connection from home
wireless or wired network.
•
The use of mobile hot spots or public wireless
connections is not recommended.
Picture
Power is on but screen
image is off.
•
Check if the connection for your source device is
properly secured.
•
Check if the correct input is selected by pressing
w
(INPUT)
.
•
Verify that your HDMI mode, for the input selected
matches the resolution output of your source device.
Change source input until you have picture and
sound.
Picture on HDMI
Input
Television has sound
with no picture or
abnormal picture.
•
HDMI EDID Version setting is set to a different mode
than your source device. To change it, refer to the step
“7 Connecting your devices” in the previous page and
see “Changing input to devices that are connected to
the TV”.
•
Change the resolution output of your source device.
Performance
Remote response is
delayed or sluggish
during initial use.
•
Your television is automatically, downloading and
installing the latest applications, for the best user
experience.
•
During this time, you may experience a delayed
response from your remote. Upon successful
installation, your remote will operate normally.
9
Troubleshooting
For further assistance, call the customer support service in your country.
- To obtain assistance, contact Philips customer care center;
In the U.S.A., Canada, Puerto Rico, or the U.S. Virgin Islands
1 866 309 5962
Enter below the model and serial numbers located on the left side and the rear of the TV cabinet.
Model :
Serial :
Category
Problem
Tip
Accessibility
Television is speaking
prompts out-loud.
•
To disable the TalkBack on your television, press
a
(HOME)
on your remote, navigate to settings icon in
the upper right corner of the home screen and select
Device Preferences
>
Accessibility
, select
TalkBack
,
press
OK
to toggle between on or off.
Sound on
HDMI with
external devices
Television has no sound.
•
Please check to be sure the device is connected to
the HDMI 2 (ARC) input on the TV.
Google Duo
USB webcam does not
work
•
Check if the webcam supports Android 9.0 or later.
(May be listed on webcam packaging or manufacturer's
website)
•
Check if the webcam is connected to the TV with a
USB cable.
•
Turn off the TV and disconnect/reconnect the
webcam with a USB cable. Turn the TV back on and
reopen the Duo app.
•
If issues remain, please visit the Duo support page
and check the Troubleshoot section.
(
https://support.google.com/duo
)
Other party cannot hear
anything
(My microphone does
not work)
•
Check if your microphone is muted. (Please unmute if so)
•
Check if the webcam has a built-in mic and supports
Android 9.0 or later. (May be listed on webcam
packaging or manufacturer's website)
•
Check if the webcam is connected to the TV with a
USB cable.
•
Turn off the TV and disconnect/reconnect the
webcam with a USB cable. Turn the TV back on and
reopen the Duo app.
•
If issues remain, please visit the Duo support page
and check the Troubleshoot section.
(
https://support.google.com/duo
)
I cannot hear other party
(Speaker does not work)
•
Check if the volume of the TV is muted or very low.
(Please unmute or turn the volume up if so)
•
Check if the webcam is connected to the TV with a
USB cable.
•
Turn off the TV and disconnect/reconnect the webcam
with a USB cable. Turn the TV back on and reopen the
Duo app.
•
If issues remain, please visit the Duo support page
and check the Troubleshoot section.
(
https://support.google.com/duo
)
Where can I find Google
Duo app?
•
Open the Google Play store and search “Google Duo”.
From here, you can download or open the app. Once
downloaded, you will be able to find it in the Apps tab
in the home screen.
Privacy
The microphone on your
TV is muted, but the
Google Assistant on the
remote still activates
when you press the
Google Assistant button.
•
This is correct. The microphone switch only disables
the built-in microphones on the TV, which is always
on to recognize the voice command “Hey Google”.
The microphone on the remote will not activate unless
the Google Assistant button on the remote is pressed.
Specifications
Parental Controls
You can restrict your children from watching certain programs or channels, by setting parental
controls using a rating lock.
How to set up Parental Controls
1.
On the Android TV home screen, select
Settings
in the upper right corner of the screen, and press
OK
.
2.
Select
Channel
>
Parental Controls
and press
OK
.
3.
Enter your
PIN (*)
>
Program Restrictions
>
Ratings
.
4.
Select
Ratings
as described in the table below and press
OK
.
C
Note:
Default setting of PIN is “1234”.
If you have forgotten the current 4-digit PIN code, you can reset the code by performing Factory
data reset.
Program Restrictions
is displayed only when the last selected input is not HDMI.
¢
Rating types and restriction levels
United States
United States (Film ratings)
TV-Y TV-Y7 TV-G TV-PG TV-14 TV-MA
G
PG
PG-13
R
NC-17
X
High Restrictions
Content suitable for
children
P
P P P
P P P P
Medium Restrictions
Content suitable for
older children
P P P
P P P P
Low Restrictions
Content suitable for
teens
P
P
SafeSearch filter for Google search
SafeSearch can help you block inappropriate or explicit images from your Google search results.
The SafeSearch filter helps block most adult content from your television. Parental supervision is
strongly recommended.
1.
On the Android TV home screen, select
Settings
in the upper right corner of the screen, and press
OK
.
2.
Select
Device Preferences
and press
OK
.
3.
Select
the Google Assistant
and press
OK
.
4.
Select
SafeSearch filter
and press
OK
.
8
Parental Control
Model #
75PFL5766
65PFL5766
55PFL5766
50PFL5766
43PFL5766
Picture
Type
UHD (Ultra HD) (3840 x 2160 pixels 60 Hz)
Diagonal screen size / Aspect ratio
74.5 ”/ 16:9
64.5 ”/ 16:9
54.6 ”/ 16:9
49.5 ”/ 16:9
42.5 ”/ 16:9
Viewing angles
178° (V) by 178° (H)
Built-in digital / analog tuner
ATSC (digital) / NTSC (analog)
Sound
Mono / Stereo
Mono, Stereo
Power output (RMS watts)
10 W x 2
8 W x 2
Equalizer
5 band
Ease of use
Picture format
SD (4:3 source)
Automatic/Full/Unscaled/4:3/Movie expand
HD (16:9 source)
UHD
Channel
Channel coverage
Over-the-Air DTV
(ATSC)
VHF: 2
~
13
UHF: 14
~
69 (Each channel may have e.g. 2.1
~
2.9, 3.1
~
3.9, etc)
Over-the-Air Analog
(NTSC)
VHF: 2
~
13
UHF: 14
~
69
CATV (Analog NTSC)
2
~
13, A
~
W
W+1
~
W+94 (Analog W+1
~
W+84), A-5
~
A-1, 5A
Tuning system
Channel frequency synthesized tuning system
Channel access
Direct access number keyboard, Programmable scan and
C (up) / - (down)
Connectivity
Composite video input
1
HDMI input
3 (selectable HDMI modes)
Supporting HDMI video signals : 480i/p, 720p, 1080i @60 Hz, 1080p, 2160p @24/30/60 Hz
Supporting HDMI HDR signals : HDR10, HLG (Hybrid Log-Gamma)
Supporting HDMI digital audio signals : LPCM, AC3, DD+
Supporting PC-input video signal up to 4096 x 2160
Analog audio L/R input
1 (L Audio / R Audio)
PC input
Via HDMI and HDMI-DVI + Analog audio L/R
USB
1
Wireless LAN
Wireless LAN Supporting wireless standards : IEEE 802.11a/b/g/n/ac
(2.4 GHz/5 GHz)
Ethernet port
1
Digital audio output
1
Supporting Dolby Audio
Headphone output
1
1/8 ” (3.5 mm)
Power
Power requirements
120 V
~
+/- 10 %, 60 Hz +/- 0.5 %
Temperature
Operating temperature
41 °F (5 °C) to 104 °F (40 °C)
* Specifications are subject to change without prior notice.
License
Funai Corporation, Inc. hereby offers to deliver, upon request, a copy of the complete corresponding source code for the copyrighted open
source code packages, on an “AS IS” basis, used in this product for which such offer is requested by the respective licenses. This offer is
valid up to three years after the product purchase to anyone in receipt of this information. To obtain source code, please contact
Funai Corporation, Inc. You should write to Funai Service Corporation OSS Request, 2425 Spiegel Drive, Groveport, OH 43125, USA.
Funai Corporation, Inc. disclaims any and all warranties and representations with respect to such software and related source code
including quality, reliability, usability, and accuracy, and further disclaim all express, implied, statutory or otherwise, including without
limitation, any implied warranties of title, non-infringement, merchantability, or fitness for a particular purpose. Funai Corporation, Inc. shall
not be liable to make any corrections to the open source software or source code or to provide any support or assistance with respect to it.
Funai Corporation, Inc. disclaims any and all liability arising out of or in connection with the use of this software and/or source code.
Copyright
All other registered and unregistered trademarks are the property of their respective owners.
The terms HDMI and HDMI High-Definition Multimedia Interface,and the HDMI Logo are trademarks or
registered trademarks of HDMI Licensing Administrator, Inc. in the United States and other countries.
Manufactured under license from Dolby Laboratories. Dolby, Dolby Audio, and the double-D symbol are
trademarks of Dolby Laboratories Licensing Corporation.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any
use of such marks by Funai Electric Co., Ltd. is under license. Other trademarks and trade names are
those of their respective owners.
Google, Android, Google Play, Android TV and other marks are trademarks of Google LLC.
Use of this TV requires consent to Google Terms of Service and Privacy Policy.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Features and specifications are subject to change without notice.
Network services, content, and the operating systems and software of this Product may be subject to individual terms and conditions and
changed, interrupted or discontinued at any time and may require fees, registration and credit card information.
The American Academy of Pediatrics discourages television viewing for children younger than two years of age.
Some features may require an always-on broadband internet connection, firmware update and/or a minimum bandwidth. Internet services
vary by location.
For complete instructions, please visit
www.philips.com/support
to download the full version of the online user manual.
This product has been manufactured by and is sold under the responsibility
of Funai Corporation, Inc., and Funai Corporation, Inc. is the warrantor in relation to this product.
The Philips trademark and the Philips shield emblem are registered
trademarks of Koninklijke Philips N.V. used under license.
1-866-309-5962
http://tinyurl.com/y2e29xsq
Call us:
Chat with us:
Scan to call us:
Scan to chat with us:
For further assistance, please call the customer support in your
country or check the Philips website for chat support.
To obtain assistance, contact Philips customer care center;
In the U.S.A., Canada, Puerto Rico, or the U.S. Virgin Islands