Technical Note
Phonak Roger Focus
Vers.:
Page:
Date:
V1
1 of 3
14.05.2014
ID Label / Label Location
Phonak Roger Focus
Pursuant to §2.925 of 47 C.F.R. the model Roger Focus, which is subject of this filing, shall bear a
permanently affixed, readily visible label listing the information as specified in §2.926 and §15.19(a) of 47
C.F.R. Due to the specific use of this assistive hearing device (as shown on Figure 1) its external surface is
in a permanent contact with the skin behind the ear. Therefore, it is not appropriate to permanently affix a
label on the outer surface of the device in order to prevent any possible skin irritations. The only possible
place where the FCC ID and the serial number of the device can be put is the battery compartment. However,
in this case the size of the FCC ID will be smaller than 2 points, which does not satisfy the requirements for
“readily visible” label as defined in §2.925(d)(2) and §2.925(g).
Therefore, due to the very small size of the device and pursuant to paragraph §15.19(a)(5) of 47 C.F.R., the
FCC ID and the statement specified in §15.19(a)(3) are placed in the user manual as shown in the example
on Figure 2.
Figure 1. Roger Focus
