HTZ-929DVR Setup guide
(please complete the S-DVR9ST Speaker setup guide
first
)
AC IN
FRONT
CENTER
R
L
FRONT
CENTER
R
AC IN
L
SURROUND
RS
LS
SPEAK
FRONT
CENTER
R
L
SURROUND
RS
LS
SPEAK
Green
Green
Red
Gray
Gray
White
Blue
Green
White
White
Gray
Blue
Blue
Red
Before connecting, twist
off the protective shielding
on each end.
Red
TV
VCR
Antenna/cable TV
wall outlet
Audio/Video out
Antenna in
Antenna out
Video in
OUT
IN
FM UNBAL
75
Ω
AM
LOOP
P
R
P
B
Y
VHF/UHF ANTENNA
AM/FM ANTENNA
CONTROL
IN
USE ONLY WITH S-DVR9 SW
OPTICAL DIGITAL AUDIO
OUT
OUT
OUT
IN
IN
L
R
R
L
R
L
L
R
ANALOG AUDIO
AUDIO
S - VIDEO
S - VIDEO
VIDEO
VIDEO
MONITOR
OUT
LINE1 IN
(AUTO START REC)
VIDEO
AUDIO
S - VIDEO
VIDEO
AUDIO
S - VIDEO
COMPONENT
AC IN
IN 1
IN 2
SCREW
MAX4mm
LINE3
IN
LINE OUT
Antenna in
OUT
IN
FM UNBAL
75
Ω
AM
LOOP
PR
PB
Y
VHF/UHF
ANTENNA
AM/FM AN
TENNA
CO
SCREW
MAX4m
m
FRONT
SURROUND
CENTER
R
R
L
L
OUT
IN
FM UNBAL
75
Ω
AM
LOOP
P
R
P
B
Y
VHF/UH
F ANTENNA
AM/FM AN
TENNA
CONTRO
L
IN
USE ONLY W
ITH S-DVR
9 SW
OPTICAL D
IGITAL AUDI
O
OUT
OUT
OUT
IN
IN
L
R
R
L
R
L
L
R
ANALOG AUDI
O
AUDIO
S - VIDEO
S - VIDEO
VIDEO
VIDEO
MONITOR
OUT
LINE1 IN
(AUTO ST
ART REC)
LINE 3
IN
LINE OUT
VIDEO
AUDIO
S - VIDEO
VIDEO
AUDIO
S - VIDEO
COMPONEN
T
AC IN
IN 1
IN 2
SCREW
MAX4mm
Connect the DVD-RW/HDD Tuner to the powered subwoofer
Connect the speakers to the powered subwoofer
Please also see the S-DVR9ST Speaker setup guide.
Plug in
CAUTION:
When
connecting this system or
changing connections, be
sure to switch power off
and disconnect the power
cable from the wall socket.
Only after completing all
connections, connect the
power cable to the wall
socket.
CAUTION:
Do not connect the supplied speakers
to another amplifier or system. This could damage
the speakers, or result in fire.
Each speaker cable, speaker and terminal on the
powered subwoofer is color coded. Connect the colored
side of each speaker wire to the colored terminals; the
other side to the black.
Push the terminal tab to open; insert the wire, making
sure there are no stray strands. Release the tab to secure
the wire.
Connect all the speakers in the same way.
a
b
Connect the supplied power cables to the
AC IN
sockets of the DVD-RW/HDD tuner and subwoofer units.
Connect the power cables to a wall socket.
1
Connect the DVD-RW/HDD Tuner to your TV and VCR
IMPORTANT:
Do not connect the DVD-
RW/HDD Tuner to your TV via a VCR. Due to
copy-protection technology the picture may
be distorted. Always connect the DVD-
RW/HDD Tuner directly to your TV.
NOTE:
You can find details of other
connections in chapter 16 of the main
Operating Instructions.
3
2
4
Bend the stand in the
direction indicated by the
arrow.
Clip the loop onto the
stand.
If you want to fix to a wall or
other surface, perform this
step after first securing the
stand with screws.
It is recommended that
you determine the reception
strength before securing the
stand with the screws.
Assembling the AM loop antenna
a
b
c
Powered subwoofer
AM loop antenna
Surround left
Surround right
Front left
Center
Front right
FM wire antenna
16-pin system cable B (black plugs)
12-pin system cable A (blue plugs)
DVD-RW/HDD Tuner
CAUTION:
These speaker terminals carry
HAZARDOUS LIVE voltage
. To prevent the risk of
electric shock when connecting or disconnecting
the speaker cables, disconnect the power cord
before touching any uninsulated parts.
POWER CORD CAUTION:
Handle the power cord by
the plug. Do not pull out the plug by tugging the cord and
never touch the power cord when your hands are wet as
this could cause a short circuit or electric shock. Do not
place the unit, a piece of furniture, etc., on the power
cord, or pinch the cord. Never make a knot in the cord or
tie it with other cords. The power cords should be routed
such that they are not likely to be stepped on. A damaged
power cord can cause a fire or give you an electrical
shock. Check the power cord once in a while. When you
find it damaged, ask your nearest Pioneer authorized
service center or your dealer for a replacement.
If the AC plug of this unit does not match the AC outlet you
want to use, the plug must be removed and appropriate one
fitted. Replacement and mounting of an AC plug on the
power supply cord of this unit should be performed only by
qualified service personnel. If connected to an AC outlet, the
cut-off plug can cause severe electrical shock. Make sure it
is properly disposed of after removal.
The equipment should be disconnected by removing the
mains plug from the wall socket when left unused for a long
period of time (for example, when on vacation).
D3-4-2-2-1a_A_En
Connecting the DVD-RW/HDD tuner
Connect the supplied yellow video cable to
the
MONITOR OUT VIDEO
jack on the DVD-
RW/HDD tuner and a video input on your TV.
Connect the antenna/cable TV wall outlet to
the
VHF/UHF ANTENNA IN
connector on the
DVD-RW/HDD tuner.
Use an RF antenna cable to connect the
VHF/UHF ANTENNA OUT
connector on the
DVD-RW/HDD tuner to the antenna input on
your VCR (or directly to your TV if you're not
connecting a VCR).
a
b
Connecting your VCR
Use a three-way RCA audio/video cable to
connect your VCR to the
LINE 3 IN AUDIO
and
VIDEO
jacks.
Use an RF antenna cable to connect the
antenna output of your VCR to the antenna
input on your TV.
d
e
c
c
a
e
b
d
<ARE7350-A>
If you're not connecting
a VCR, connect the RF
antenna cable from the
antenna/cable TV wall
outlet directly to the
DVD-RW/HDD Tuner.
XV-DVR9H_ARE7350A.fm Page 1 Thursday, September 30, 2004 5:28 PM
