English
The speaker units in this speaker system are magnetically shielded.
However, colours may blur if the speakers are positioned too close to a
television screen. If this happens, switch off the television and switch it
back on again after 15 to 30 minutes. If the problem persists, move the
speakers away from the television set.
BEFORE OPERATION
Thank you for buying this PIONEER product.
The S-SP410 system can be combined with the S-W90S to produce a 5.1
channels speaker system.
Read the Instruction Manual carefully before using this speaker system so that
you can operate it properly. After you have finished, put this manual away in a
safe place for future reference.
The rated impedance of this speaker system is 8
W
. It must be connected to a
amplifier which accepts this type of load (miminum and maximum impedances
accepted by the amplifier are generally indicated near the loudspeaker outlets:
for example "4
W
to 16
W
" or "6
W
to 16
W
").
To guard against damage to this speaker system due to an electric power
overload, take the following precautions:
Do not supply more than the maximum permitted power to the speaker
system (see Specifications).
Any connection or switching on or off of part of the audio system (CD
player, tuner etc.) must be carried out after switching off the amplifier or at
least with the loudspeaker outlets disconnected (if the amplifier allows).
Interference caused by these operations will otherwise reach the speaker
and may damage the treble loudspeaker units.
When boosting particular frequencies using a graphic equaliser or bass
and treble correctors, make sure that you do not increase the amplifier
volume excessively, as the speaker will be overloaded more quickly.
Do not force a low-power amplifier to produce a high level of sound as
harmonic distortion increases rapidly in this situation and may pose a
danger to the treble speaker units.
Avoid touching the diaphragms and suspensions of speaker units as they are
fragile
REMARK :
The specifications and design of this product are subject to change
without notice, in the interests of improvements.
REMARKS :
Check that the cables are securely connected to the terminals. A loose
connection may cause not just intermittent or distorted sound but short-circuiting
and breakdown of the amplifier.
If the cables of one of the speakers have been connected with the wrong
polarities, you will find when listening to a stereo recording that bass sounds are
weakened and the stereo effect normally obtained between the two speakers
does not exist.
MAINTENANCE OF THE ENCLOSURE
Use a cloth to wipe away dust and dirt.
If the enclosure is very dirty, wipe with a soft cloth dipped in a neutral detergent
diluted five to six times with water, then wipe again with the dry cloth. Do not use
thinner, benzene, cleaning sprays or other chemical products on or near the
enclosures as the surfaces could be adversely affected.
SPEAKER SYSTEM
ENCEINTE ACOUSTIQUE
LAUTSPRECHERSYSTEM
SISTEMA ALTOPARLANTE
LUIDSPREKERSYSTEEM
HÖGTALARSYSTEM
SISTEMA DE ALTAVOCES
SISTEMA DE ALTIFALANTES
INSTRUCTION MANUAL
MODE D'EMPLOI
BEDIENUNGSANLEITUNG
GUIDA PER L'USO
GEBRUIKSAANWIJZING
BRUKSANVISNING
GUIA DE OPERACIÓN
GUIA DE OPERAÇÃO
Published by Pioneer Corporation.
© 2007 Pioneer Corporation.
All reproduction and translation rights reserved.
Printed in China <PM-11003-10091-AFQ>
SPECIFICATIONS
Speaker
Front - Rear speaker..............................Floor-standing type, enclosed
Centre............................................................Compact type, enclosed
System
...............................................................................2 ways, 5 speaker units
Speaker units
Woofers ........................................ Cone speaker units, 50 mm x 4
Tweeter ..........................................................1 Dome type, 20 mm
Nominal Impedance
......................................................................................8
W
Frequency range :
................................................................ 150 Hz to 20 000 Hz
Sensitivity
....................................................................... 85 dB/W at 1 m distance
Maximum power
.......................................................................................... 100 W
Dimensions
Front - Rear speaker............................ 210 mm (W) x 1050 mm (H) x 210 mm (D)
Centre speaker........................................... 370 mm (W) x 68 mm (H) x 48 mm (D)
Weight
Front - Rear speaker.......................................................................................... 3 kg
Centre speaker................................................................................................ 0.9 kg
INSTALLATION PRECAUTIONS
The S-SP410 system is composed of 1 centre, 2 front and 2 rear speakers.
For optimum sound reproduction of high frequencies, the treble speaker units
must be at the same height as the listener's ears.
For low frequencies, it is possible to increase the level of bass sounds by
positioning the speakers close to a wall (the maximum increase being obtained
for a position in a corner of the listening room).
Do not install these speakers close to an oven or heating appliance. Avoid
exposing them to direct sunlight. High temperature can distort the structure of the
enclosure and adversely affect the sound.
These speakers are heavy and fragile, therefore it is dangerous to install them
in an unstable position.
This system is used in conjunction with the S-W90S subwoofer
S-SP410
S-SP410-K
Install the centre speaker above or below the TV so that the sound of the center
channel is localized at the tv screen.
CONNECTIONS
Switch off the amplifier power supply (OFF).
Connect the cables to the input terminals on the rear of the speaker: Connect
the neutral cable to the
terminal and the live cable to the
terminal. Do not
forget that the red input terminal has positive polarity and that the black input
terminal has negative polarity.
+
+
Connect the cables to the loudspeaker outlet terminals of the amplifier. Connect
the live cable to the
terminal and the neutral cable to the
terminal.
1. Strip the insulation at the tip of
the cord and twist the strands
2. Connect the common-side speaker
cord to the
terminal
3. Connect the hot-side speaker cord to
the
terminal
+
+
+
Accessory parts
Instruction Manual ................................................................................................. 1
Warranty ................................................................................................................ 1
Cables.................................................................................................................... 5
Centre Speaker
Tall-boy Speaker
S-SP410_410-K_8L.fm 1 ページ ２００７年８月１０日 金曜日 午後６時１９分
