Congratulations: You have purchased a product of superior
performance and design, which will give the best service when
properly operated and maintained. This cooler is intended to be
used as a convenient roll-around spot cooler.
This guide was designed to provide you with the information
needed to prepare the unit for roll-around spot-cooling. It also
contains information on how to safely operate, inspect, maintain
and troubleshoot your Patio Pal evaporative air cooler.
The first section contains instructions to prepare your cooler for
roll-around portable service. The second section, Maintenance,
contains operational and maintenance instructions to aid in
keeping your unit in good working order, while Troubleshooting
includes information to help diagnose and repair commonly
encountered problems.
READ AND SAVE THESE IMPORTANT SAFETY
INSTRUCTIONS
Read all instructions carefully before installation
• This cooler must be connected to 120 volt AC, 60 Hz (cycle)
power only. NOTE: Improper voltage will void the pump and/
or motor warranties and may cause serious personal injury or
property damage.
• This cooler must be plugged into a GFCI protected receptacle,
which has been properly installed in accordance with all local and
national codes. If you are not sure that the receptacle is GFCI
protected, consult with a qualified electrician.
• This cooler is equipped with a power cord having an
equipment grounding conductor and grounding plug. Do
NOT
attempt to defeat this safety device by removing the grounding
pin.
• Do
NOT
attempt to lift the unit by side handles.
• Do
NOT
step on or rollover power cord with heavy or sharp
objects. Do
NOT
operate if plug or cord is damaged in any way. If
the unit is damaged or malfunctions, do
NOT
continue to operate it.
• Remove the plug from the electrical receptacle by pulling on the
plug and not the cord.
• Always disconnect electrical power to unit before
attempting to work on or service your cooler.
• Do
NOT
operate with evaporative pad removed.
• Do
NOT
use this unit as a step stool or ladder. Do not sit,
stand, or lean on this unit.
Serious risk of personal injury or
property damage may occur.
• Do
NOT
operate lid unless BOTH gas springs are functioning
properly
Serious risk of personal injury or property damage
may occur.
OWNER’S GUIDE
USE AND CARE MANUAL
MODEL PP5000
01-999-2521
Page 1
Safety Trouble Shooting
Operation Parts Replacement
Maintenance
READ THIS FIRST!
WARNING
- TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING
• Do
NOT
operate this cooler (fan motor) with any solid-state
speed control device.
• Do
NOT
operate with pad frame removed. Do not
place fingers or any other objects inside the fan section.
Serious risk of personal injury or property damage may occur.
• Never wash your cooler cabinet with a garden hose, water
may harm motor and pump.
• Do
NOT
attempt to move or operate the unit with damaged or
missing casters. The unit may become unstable and result in
serious personal injury or property damage.
NOTE:
• Do
NOT
use indoors on carpet or wood floor. Unit may leak
water and could damage flooring or create a slip hazard.
• Do
NOT
locate or operate cooler near exhaust or vent pipes
as odors or fumes may be drawn into unit.
• Your warranty does
NOT
cover shipping damage. Report all
shipping damage at once to store making the delivery.
• For future reference, record the serial number and
purchase date of your evaporative cooler here:
Serial #____________________________________________
Purchase Date:_____________________________________
Place of Purchase:___________________________________
CAUTION: the use of anode devices, chemical additives
or cooler cleaner treatments in this cooler will void the
warranty.
01-999-2521
Page 8
Phoenix Manufacturing, Inc., Phoenix Arizona, extends this limited warranty to the original purchaser of this evaporative cooler.
What this warranty covers and for how long:
FIVE YEAR COVERAGE:
Phoenix Manufacturing Inc. will exchange the cabinet only should any water leakage occur through the base assembly due to rust out, or as a result of
defect in material or workmanship during the first five years from the date of initial purchase.
THREE YEAR COVERAGE:
applies to the fan motor if furnished by Phoenix Manufacturing Inc.
ONE YEAR COVERAGE:
applies to all other components if furnished by Phoenix Manufacturing Inc. Phoenix Manufacturing Inc, at their discretion, will exchange or replace all
components should they fail as a result of a defect in material or workmanship during the first year from date of initial purchase.
Media is a disposable item and has no warranty.
What this warranty does NOT cover:
PMI is not responsible for any damage or malfunction unless caused by a defect in material or workmanship. Determination of defects in materials or workmanship is at the sole
discretion of PMI or its appointed representative.
DAMAGE OR MALFUNCTION, WHICH IS NOT COVERED BY THIS WARRANTY, INCLUDES, BUT IS NOT LIMITED TO:
√
Pad media
√
Abuse or misuse
√
Worn belts
√
Improper installation, maintenance or operation
√
Water damage to motor
√
Transportation damage
√
Acts of God
• Do not use anode devices, water from a water softener, cooler cleaners, cooler treatments or other additives in your cooler.
The use of any of these products will void your warranty and may impair the life of your cooler.
• This warranty does
NOT
cover evaporative coolers installed and operated outside the continental United States.
• PMI does
NOT
pay the cost of a service call to the site or installation to diagnose the cause of trouble.
• PMI does
NOT
pay the cost of labor to install the part, or mileage allowance to or from the site.
• PMI does
NOT
pay the freight / postage on any exchange or replacement parts.
• This warranty does
NOT
cover any failure, damage, or defect that results from unauthorized modification or service, or from the use of products or replacement parts other than
those from PMI, including, but not limited to motors and pumps.
To obtain service under this warranty:
Contact the dealer where you purchased your evaporative cooler. Include your name, phone number, address and zip code, the model and serial number of your evaporative cooler,
a copy of your proof of purchase, date of installation and a description of your problem.
If you are not able to locate your dealer, or in case of unsatisfactory warranty service from your dealer, please write the Warranty Department, PMI, 3655 E. Roeser Road, Phoenix,
Arizona, 85040. Include your name, phone number, address and zip code, the servicing dealer involved, the model and serial number of your evaporative cooler,
a copy of your
proof of purchase
, date of installation, and a description of your problem.
Replacement Parts:
All PMI replacement parts carry a 90-day warranty from date of purchase (or balance of original warranty, whichever is greater).
This warranty is the only warranty extended by PMI to consumer purchasers of evaporative coolers. PMI disclaims all other warranties, expressed or implied, that arise by the
operation of the law, except that implied warranties of merchantability or fitness for a particular purpose are limited to the duration of the expressed limited warranty period. PMI shall
not be liable to any incidental or consequential damages, above the limitations or exclusions stated above which may have resulted from any alleged breach of warranty.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, the limitations or exclusions stated
above may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state.
Evaporative Cooler - Limited Warranty
Phoenix Manufacturing,Inc.Phoenix, Arizona, extiende esta garantía limitada al comprador original de este enfriador evaporativo.
Lo que esta garantía cubre y por cuanto tiempo:
Cobertura de cinco años
Phoenix Manufacturing Inc intercambiará el gabinete, si es que fugas de agua ocurran a través del fondo debido a oxidación, como resultado de material defectuoso o de mano de obra
durante los primeros cinco años de la fecha de su compra inicial..
Cobertura de tres años
se aplica a motor de ventilador si propoecionado por PMI.
Cobertura de un año
se aplica a todos los componentes si fue proporcionado por PMI. PMI a su discreción, intercambiará o remplazará, todos los componentes si es que fallan como resultado de defectos en
material o mano de obra durante el primer año de la fecha de su compra inicial.
Paja es un articulo desechable y no tiene garantía.
Lo que NO cubre esta garantía:
PMI no es responsable por ningún daño o mal funcionamiento al menos que sea causado por defectos de material o mano de obra. Determinación de defectos de material o mano de obra es solamente a la
discreción de PMI o su representante designado.
DAÑOS DEBIDO A MAL FUNCIONAMIENTO QUE CUBRE ESTA GARANTIA INCLUYEN, PERO NO SE LIMITAN A :
√
Filtros (paja)
√
Abuso o mal uso
√
Bandas gastadas
√
Impropia instalación, mantenimiento, u operación
√
Daño de agua al motor
√
Daños de transportación
√
Actos de Dios
• No use dispositivos de ánodos, agua de un sistema de agua blanda, limpiadores para enfriador, tratamientos para enfriador, u otros aditivos en su enfriador. El uso de cualquiera de estos productos anulará la
garantía y posiblemente acortar la vida de su enfriador.
• Esta garantía no cubre enfriadores instalados y operados fuera del continente de los Estados Unidos.
• PMI NO paga el costo de llamada de servicio a la instalación para diagnosticar la causa del problema.
• PMI NO paga el costo de labor para instalar la parte, o el costo del millaje hacia o del lugar.
• PMI NO paga por el costo de flete/postal o cualquier intercambio o reemplazo de partes.
• Esta garantía NO cubre ninguna falla daño, o defecto que resulte por modificación no autorizada o servicio, o por el uso de productos o partes de reemplazo que no sean de PMI incluyendo, pero no limitado a
motores y bombas.
Para obtener servicio bajo esta garantía :
Contacte su proveedor en donde compró su enfriador. Incluya su nombre, número de teléfono, dirección y zona postal, el modelo y número de serie de su enfriador evaporativo,
una copia de prueba de
compra, fecha de instalación y descripción del problema.
Si no puede localizar su proveedor, o en caso de servicio de garantía insatisfactorio, favor de escribir Departamento de garantía, PMI, 3655 E. Roeser Road, Phoenix, Arizona, 85040. Incluya su nombre, número
de teléfono, dirección y zona postal, el taller de servicio envuelto, el modelo y número de serie de su enfriador evaporativo,
una copia de prueba de compra
, fecha de instalación y descripción del problema.
Partes de reemplazo :
Todos las partes de reemplazo de PMI cuentan con una garantía de 90 días desde la fecha de su compra (o el balance de la garantía original lo que sea más).
Esta es la única garantía extendida por PMI al consumidor que compra enfriadores por evaporación. PMI desconoce todas otras garantías, expresadas, que surjan por la operación de la ley, excepto que
garantías implicadas de comerciabilidad o conveniencia para un propósito particular son limitadas a la duración del limitado período de garantía expresado. PMI no deberá ser responsable por daños incidentales
o consecuentes, las limitaciones o exclusiones declaradas arriba que posiblemente hayan resultado de cualquier declaración de garantía rota.
Algunos estados no permiten limitaciones en que tanto el contenido de una garantía dure o la exclusión o limitación de daños incidentales o consecuentes, las limitaciones o exclusiones indicadas arriba es
posible que no se la aplique a usted. Esta garantía le da a usted derechos específicos legales, y es posible que usted tenga otros derechos que varían de un estado a otro.
Garantia Limitada - Enfriador Evaporativo
