Mount Ceiling plate To Ceiling
1
Fixing Kit
Pre assembled
Note:
Ceiling fixings are not supplied. Use the correct fixings
appropriate for the ceiling material and structure.
A:
Position Pole Adapter over exsisting 50mm pole
B:
Insert all 4 grub screws from the fixing kit to retain the
pole adapter in position.
A
H -
Grub Screw
M6 x 8mm
x4
F -
Spacer
x20
G
-
of each
Struts
Short,
Medium,
Long
x2
E
-
Washer
M3,
M4,
M5,
M6
x4
x4
x4
x4
C
-
Screw
M3 x 25mm
M4 x 25mm
M5 x 25mm
M6 x 25mm
x4
x4
x4
x4
B
-
Screw
M3 x 10mm
M4 x 10mm
M5 x 10mm
M6 x 10mm
x4
x4
x4
x4
Pole adapter
Projector mount
Button head bolt
M8 - 75mm
Tilt washer
Tilt lock washer
B
pmv
mounts
.co.uk
Ÿ
Read these instructions carefully before installing your equipment.
Ÿ
Install the mount in a suitable location using fixings which are appropriate for
the ceiling material and structure. Consult a qualified builder if you’re in any doubt as
to the structural integrity of the ceiling.
Ÿ
Do not attempt to alter or modify any part of the ceiling mount or its attachments.
Ÿ
Do not use if any parts are broken or appear to be damaged.
Ÿ
Tighten all bolts and fixings securely. Only use fixings provided with this bracket.
Ÿ
Do not mount your projector close to sources or heat or moisture.
Ÿ
Always have a minimum of two persons to install the projector on to the mount.
Mounting instructions for 50mm Pole-adapter projector mount
Fits any 50mm diameter ceiling poles.
Maximum projector fixing points up to 630mm x 325mm - Up to 25Kgs
Model No.
PMVMOUNT1PA
Factory No.
Z0874PA
A
-
Button head screw
M6 x 8mm
x4
