Quick reference guide
Thank you for purchasing Polaroid’s liquid-crystal-display
(LCD) projection panel. This quick-setup information is
common to both the Polaview Model 1700 and Model 1900
Projection Panels, except where indicated.
Quick setup
1
Turn off your computer system and overhead projector.
procedures
Place your panel on the overhead projector.
2
Connect the video Y-cable as shown below for either
VGA or Macintosh II systems. VGA systems use cable part
number C454-6, Macintosh II systems use cable part num-
ber C464-6.
3 Power:
With your panel POWER switch in the Off position,
connect the AC adapter to the panel power connector, then
plug the power cord into the adapter. Finally, plug the
power cord into a grounded AC wall outlet.
4
Turn on your panel first, then the computer, monitor, and
finally the overhead projector.
MON (monitor)
LCD
CPU
(computer/VGA)
Polaview 1700/1900
