Exchange of the original Polaroid SprintScan 120 Eprom
Safety instructions!
First please remove all external cables from the device.
Never open your Polaroid SprintScan while it is attached to a power supply.
With devices attached to electricity mains mortal danger exists!
Ground yourselves.
If you do not own a grounding bracelet, please touch a heating element or other grounded
structure before touching any chips or circuit board.
Read this entire manual before you start disassembleing your scanner.
The installation of the chip takes place on your own responsibility.
Opening the casing
First you have to remove the screws fastening the case.
Carefully turn your Polaroid SprintScan 120 on it's back.
Start with the screw for the front cover (central screw towards the front).
Before you remove the other screws turn the dvice back on it's feet.
Attention: the rear cover screw does not have to be removed.
© LaserSoft Imaging
1/6 pages
